Separate names with a comma.
Here are some things that i hope will help you.
(in the future ?)
I brought my fan shroud down with something like this.
(i think the better...
This is the first step to change the complete head. A first simple try and not complete. But it works fine on the R2. Will give you more...
Thermistor & Heater are 24V .
If the length is nearly the original you can use them.
Here are some things i have built in.
Thanks, motor support was one of the first things i printed.
I have seen that on the top of the Z-Axis is no nut or bearing.
Right or wrong ?
I found this in the RepRap Forum:
another solution could be buying a flexplate and blue tape.
Buildtalk dont work witht the Robo R2 IR sensor..
Anyway you will get much better results with manual leveling.
The Buildtalk Flexplate and...
Shame on me !
After checking the power supply and changing the 40W Heater back to at 30W the problem still exists and so I started from the...
Last day a print without heating bed was s successful. Actually the printer stops (complete shutdown and restart) in different cases:
Power Supply cool.
Will check this with Heating.
After a lot of beginner problems i found the power supply as a reason for some undefinied errors.
In some cases the printer suddendly makes a...
So i see no holes in the stl, you use the fan mounted on the hotend ?
Thanks for the Thingiverse Work.
Do you have a picture ?
Alles in allem ein cooles Hobby.
Bis zum ersten sauberen Druck dauerts leider lang.
Vielleicht ein parr wichtigsten Sachen nochmal :
Thanks, this is what I`'am looking for. Unfortunately i did not find it so i give it back after 1 Day.
I prefer after days of testing and also damaging the print surface the following calibration steps.
Make the Z-Offset Calibration and let 5 mm...
Sorry for this misunderstanding,
i mean in Cura the settings for the support. (Enable Support Interface)
The prints in low quality are very rough...
bei mir gibts aktuell noch ein Problem mit dem Auto Bed Leveling GCode G29.
Ihr könnt Befehle ausschalten mit einem Semikolon.
Thanks for this interesting feature. Will try it.
By the way do you have working adjustments for the enabled support interface.
Anbei mal ein paar Testdrucke mit geringer Qualität.
SD Karte austauschen
Befindet sich unten im Gehäuse..
Auf der Unterseite des Raspi wo die grüne LED blinkt..
Ihr benötigt ein Imager z.B....