1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 3 of 3
  1. Thomas
    Post

    Unanswered layer adhesion problems

    I'm sure the more experienced guys will tell you specifically what is going on but I'd start with removing the bottom and checking everything...
    Post by: Thomas, Feb 25, 2016 in forum: Troubleshooting
  2. Thomas
    Post

    Unresolved Y Axis Grinding Issues

    Thanks Mike I will try that! Sent from my iPhone using Tapatalk
    Post by: Thomas, Feb 12, 2016 in forum: Troubleshooting
  3. Thomas
    Post

    Unresolved Y Axis Grinding Issues

    Hey guys, so this is off thread but following this post because I get this ransom y axis grinding when bed goes to far to the rear during self...
    Post by: Thomas, Feb 11, 2016 in forum: Troubleshooting
  4. Thomas
    Post

    Solved Manufacturer's Instructions for Changing filament

    Some people use the oilers. I just dip the first few inches into some oil every change. Maybe if you print a lot try the oiler. Not sure if that's...
    Post by: Thomas, Feb 11, 2016 in forum: Troubleshooting
  5. Thomas
    Post

    Unresolved Y Axis Grinding Issues

    I have randomly encountered the same issue but my prints are ok. I'm using R1plus with simplify3d. Interested to hear what people say. Sent...
    Post by: Thomas, Feb 10, 2016 in forum: Troubleshooting
  6. Thomas
    Post

    Solved Manufacturer's Instructions for Changing filament

    Yeah Shane, not sure what others do as I'm sure there are many tricks but I do a similar thing as Mark. My routine is: I center to home then raise...
    Post by: Thomas, Feb 9, 2016 in forum: Troubleshooting
  7. Thomas
    Post

    Solved New Robo3D does not reset to home - Z axis just goes up

    Got it thank you very helpful! Sent from my iPhone using Tapatalk
    Post by: Thomas, Feb 5, 2016 in forum: Troubleshooting
  8. Thomas
    Post

    Solved New Robo3D does not reset to home - Z axis just goes up

    WheresWaldo, would you be so kind as to post pics of correct placement positioning of the brass nut in relation to the x axis idler arm and switch...
    Post by: Thomas, Feb 5, 2016 in forum: Troubleshooting
Find older messages
Showing results 41 to 48 of 48
Search Again
Page 3 of 3