Separate names with a comma.
Thanks for the info. Good to hear the printer hasn't been totally forgotten!
Are the stepper drivers any more quiet than the original R2?
Plus it looks like it's still in development.
Been looking for a way to update my printer so I can use it again after the board pooped out.
Any updates on the use of the board?
Thanks for the trouble shooting tips. I'll dig around in there and see if that helps figure it out. Much appreciated!
For a while my pritner will make a long beeping noise while the print bed is rising to initiate a print. Wasn't a big deal and the print quality...
I've been using the newest version of Cura from Ultimaker because it gives the option of a gradual infill. One of the biggest benefits I've...
There is a sign up for being notified when the dual extruder kit becomes available at robo3d.com/pages/dual-extruder-kit.