1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. woferry
    Post

    Unresolved Y Axis Grinding Issues

    I haven't run into any grinding at Y=0 (during homing) or any printing issues, but when I received my R1+plus the Y servo would grind when going...
    Post by: woferry, Feb 11, 2016 in forum: Troubleshooting
  2. woferry
    Post

    Solved Bed traveling to far for last 3 points during autolevel process.

    If you have one of the R1(plus's?) with the ribbon cable coming out the back for the bed heater, make sure it isn't bunched-up underneath. Mine...
    Post by: woferry, Feb 7, 2016 in forum: Troubleshooting
  3. woferry
    Post

    Solved Z Axis WAYYYY off after hot end replacement

    Does the head end up rising during the bed leveling procedure? If the carriage is too tilted from left-to-right I've seen that happen, some or...
    Post by: woferry, Feb 1, 2016 in forum: Troubleshooting
  4. woferry
    Post

    First attempt at complex geometry.

    I suspect 187 was a bit too cold for the PLA, when I did a test-print where I changed temperature I had PLA that flowed fine at 190C but quickly...
    Post by: woferry, Jan 31, 2016 in forum: Show and Tell
  5. woferry
    Post

    Mike Kelly's Solenoid Auto-Level for Stock R1

    It was obvious on my R1plus that the results from G29 were automatically having an effect, as the head would move from one X extreme to the other...
    Post by: woferry, Jan 29, 2016 in forum: Mods and Upgrades
  6. woferry
    Post

    E3D v6 Information, Installation Guides, and Review

    It was sold through 3DMakerWorld, http://www.amazon.com/gp/product/B00NAK9JFO
    Post by: woferry, Jan 29, 2016 in forum: Mods and Upgrades
  7. woferry
    Post

    E3D v6 Information, Installation Guides, and Review

    So does the non-bowden version of the E3D v6 not come with ANY PTFE tubing at all?!?! After breaking the nozzle off my hexagon during a clog...
    Post by: woferry, Jan 29, 2016 in forum: Mods and Upgrades
  8. woferry
    Post

    Solved Fan makes odd sound at start of print but normal once full speed

    The 25mm fan on my 2-week-old R1plus has started up in a very noisy state a few times, the other times it's been fine. But I just got my E3D v6...
    Post by: woferry, Jan 28, 2016 in forum: Troubleshooting
Find older messages
Showing results 21 to 28 of 28
Search Again
Page 2 of 2