1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Shrp77
    Post

    Z-Index wizard doesn't work

    Between manually setting the Z-Offset (Home Offset) in the EEPROM and using the manual leveling wizard, I was finally able to get the system to...
    Post by: Shrp77, Sep 9, 2019 in forum: Troubleshooting
  2. Shrp77
    Post

    Z-Index wizard doesn't work

    I'm a total newb at this - thank you. I noticed that the model I was trying to print had a Z-Index in the model? When I manually level the bed,...
    Post by: Shrp77, Sep 8, 2019 in forum: Troubleshooting
  3. Shrp77
    Post

    Z-Index wizard doesn't work

    I tried setting a manual Z-index to a negative value, then went through the process of manually leveling it. Tried to print what I need to print...
    Post by: Shrp77, Sep 8, 2019 in forum: Troubleshooting
  4. Shrp77
    Thread

    Z-Index wizard doesn't work

    Hi, I recently brought out my R2 from storage and updated the firmware. Now, when I run the Z-Index wizard it generates a value of +12.4. I can...
    Thread by: Shrp77, Sep 8, 2019, 22 replies, in forum: Troubleshooting
  5. Shrp77
    Post

    Z calibration wizard not working

    I just checked - and the entire switch assembly is missing the top part (I'm assuming it's similar to the end-point switched used in the R1)....
    Post by: Shrp77, Jun 2, 2017 in forum: Troubleshooting
  6. Shrp77
    Post

    Z calibration wizard not working

    My R2 doesn't stop when it reaches the bottom. Afraid that the motor may burn out unless I turn it off... How important is the Z-level calibration...
    Post by: Shrp77, Jun 2, 2017 in forum: Troubleshooting
  7. Shrp77
    Post

    Robo C2 and Robo R2 Smart 3D Printers

    This is very cool - I didn't get in on the super early bird for the R2, but did get in on the early bird! Question - does the printer provide a...
    Post by: Shrp77, Sep 21, 2016 in forum: ROBO 3D News and Announcements
Showing results 1 to 7 of 7
Search Again