1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Michael J Hobe
    Post

    Solved Robo R1 Z-axis moving during first layer

    I've switched over to repetier and ot actually took care of the problem. Now it's trying to undertake the software and get the bed leveled and a...
    Post by: Michael J Hobe, Sep 20, 2019 in forum: Troubleshooting
  2. Michael J Hobe
    Post

    Solved Robo R1 Z-axis moving during first layer

    I've been using matter controller since day one but I may try another program to see if I can get different results. I should probably change...
    Post by: Michael J Hobe, Sep 16, 2019 in forum: Troubleshooting
  3. Michael J Hobe
    Post

    Solved Robo R1 Z-axis moving during first layer

    I know I was using auto leveling at one time, I've tried turning it off to see if I could achieve different results and nothing changed. I'll try...
    Post by: Michael J Hobe, Sep 16, 2019 in forum: Troubleshooting
  4. Michael J Hobe
    Post

    Solved Robo R1 Z-axis moving during first layer

    [MEDIA]Okay, after failing to add a link let's try it again. Hope this helps give you an idea. Poor angle but you can see how as the bed moves...
    Post by: Michael J Hobe, Sep 16, 2019 in forum: Troubleshooting
  5. Michael J Hobe
    Post

    Solved Robo R1 Z-axis moving during first layer

    [IMG] Here is a link after making a few more posts. Essentially the Z is shifting during the layer, not one side but both. I know they're tight...
    Post by: Michael J Hobe, Sep 16, 2019 in forum: Troubleshooting
  6. Michael J Hobe
    Thread

    Functional prints

    Im Looking for ideas on what to print that would be functional and useable around the house and workshop.
    Thread by: Michael J Hobe, Sep 16, 2019, 1 replies, in forum: Projects
  7. Michael J Hobe
    Thread

    Finishing prints

    What are some preferred methods for finishing a print. I've seen people sanding, coating and just flat out painting but what works best for you?
    Thread by: Michael J Hobe, Sep 16, 2019, 1 replies, in forum: Printing Filament
  8. Michael J Hobe
    Post

    Solved Robo R1 Z-axis moving during first layer

    I have a link but the dang bot is keeping me from adding it until I have 4 posts. One Z rod is not moving more than the other, during a print both...
    Post by: Michael J Hobe, Sep 16, 2019 in forum: Troubleshooting
  9. Michael J Hobe
    Thread

    Solved Robo R1 Z-axis moving during first layer

    As the title says, my Z-axis is rotating during the first layer resulting in an uneven layer and poor adhesion in spots. I've played with all the...
    Thread by: Michael J Hobe, Sep 11, 2019, 13 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again