1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 5 of 5
  1. WADZOQUADZ
    Post

    Marlin Firmware Upgrade 1.1.0 RC8 & RCBugFix (For R1 & R1+PLUS)

    I got it . I had to comment out define doglcd
    Post by: WADZOQUADZ, Mar 23, 2016 in forum: Mods and Upgrades
  2. WADZOQUADZ
    Post

    Marlin Firmware Upgrade 1.1.0 RC8 & RCBugFix (For R1 & R1+PLUS)

    I am trying to upload Rc3 on my Robo R1 but keep getting error Doglcd_cs was not declared in this scope .It is in dogm_lcd_implementation.h Rc3...
    Post by: WADZOQUADZ, Mar 23, 2016 in forum: Mods and Upgrades
  3. WADZOQUADZ
    Post

    Solved Filament

    +1 for hatchbox .Gizmodork is good. Makergeeks has good filament and they have a awesome grab bag special where you can get the same filament for...
    Post by: WADZOQUADZ, Mar 21, 2016 in forum: General Questions
  4. WADZOQUADZ
    Post

    Solved ABS on with the factory hex hotend?

    i dont know how you guys do it. iv never been able to print ABS on my R1 with the hex or E3d . It curls and warps on even small parts for me....
    Post by: WADZOQUADZ, Mar 21, 2016 in forum: General Questions
  5. WADZOQUADZ
    Post

    Need help .STL --> .SLDPRT convert Need a solidworks user

    Converting STL to solidworks part file (solid body) is a pain sometimes but iv been doing it successfully on at least 75% of the Stl's i try . On...
    Post by: WADZOQUADZ, Mar 20, 2016 in forum: Software
  6. WADZOQUADZ
    Post

    PETG suggestions?

    I run my Esun PETG at 240 with 80 bed , 50mm/sec and NO print fan. this is with the E3d V6 . Prints flawlessly ,even better then PLA. Not even...
    Post by: WADZOQUADZ, Mar 20, 2016 in forum: Printing Filament
  7. WADZOQUADZ
    Post

    Robo3D Replacements and Upgrades Thread

    I just finished my carriage and extruder redesign for E3D v6 and it works much better then the original parts. Fitment is excellent . Basically...
    Post by: WADZOQUADZ, Mar 20, 2016 in forum: Mods and Upgrades
  8. WADZOQUADZ
    Post

    Answered Can anyone reccomend a slicer that is not S3D?

    I gotta say , i bought S3D about a year ago and it was the best decision ever. Im not one that likes to buy something when i can use something for...
    Post by: WADZOQUADZ, Mar 16, 2016 in forum: General Questions
Find older messages
Showing results 81 to 88 of 88
Search Again
Page 5 of 5