1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. TaylarRoids
    Post

    Answered Does Your Z-axis Lock?

    Upon further inspection, it's only when I print certain things so I'm not sure what's going on. The prints that mess up look good in the slicer,...
    Post by: TaylarRoids, Apr 23, 2017 in forum: Troubleshooting
  2. TaylarRoids
    Post

    Answered OverHang tips and tricks

    ^ Good resources ^ But also: In my experience you need to A) Use the lowest possible extrusion temp B) Use the lowest possible bed temp (radiated...
    Post by: TaylarRoids, Apr 19, 2017 in forum: Troubleshooting
  3. TaylarRoids
    Post

    Answered gets stuck going up!!!!

    Mine was doing that and after a good clean/lube of the Z axis threaded rods it stopped.
    Post by: TaylarRoids, Apr 19, 2017 in forum: Troubleshooting
  4. TaylarRoids
    Post

    Answered Odd filament problem - PLA

    What layer(s) does it happen on? First or all?
    Post by: TaylarRoids, Apr 19, 2017 in forum: Troubleshooting
  5. TaylarRoids
    Thread

    Answered Does Your Z-axis Lock?

    So you know how after you home the X/Y/Z axes the X and Y torque lock so you can't move it around on accident and lose their homed positions? Can...
    Thread by: TaylarRoids, Apr 19, 2017, 4 replies, in forum: Troubleshooting
  6. TaylarRoids
    Post

    First test of FLEKS 3D build plate kit

    Another related question: since the build plates don't have the finger cut out to remove them like the pictures for the Kickstarter did, how have...
    Post by: TaylarRoids, Mar 14, 2016 in forum: Show and Tell
  7. TaylarRoids
    Post

    First test of FLEKS 3D build plate kit

    The only thing with that is that I like to preheat the extruder while I'm loading the file so it's ready to go faster, which would be a problem...
    Post by: TaylarRoids, Mar 14, 2016 in forum: Show and Tell
  8. TaylarRoids
    Post

    First test of FLEKS 3D build plate kit

    Hi! I just got the same one, I'm currently working to find some G-code that will work for the opening script in Simplify-3D. Do you have a...
    Post by: TaylarRoids, Mar 14, 2016 in forum: Show and Tell
Showing results 1 to 8 of 8
Search Again