Separate names with a comma.
Working on restoring a Robo R1
I picked up and Robo 3D R1 off craigslist. $100. The extruder connector was not attached. The small fan wire were broken off, and is was so dirty...
It didn’t do so go. Looks like x-axis not tracking straight .
Yes, that they are, they were just making noise after. I adjusted the drive current on all drivers and that took care of it.
Set all to 0.6V ....
I'm refurbishing a Robo 3d r1.
I notice if I do a Home example X axis
It goes to home but then after a few seconds it start to squeal, you...