Separate names with a comma.
Hello, did you solve the problem ? My new R2 had the same problem after several weeks, but it wasn't a software or connection problem. Heating up...
Hello, unfortunately i have to dissamble all parts of the top chassis because the bearings are rough (extruder block).
So this is a...
Thanks a lot for the helpful link and the description of the bearing.
I found a seller in Germany.
Greetings from Munich.
Thanks, removing the top was not a problem, but i have to find another solution because partsbuilt shipping costs to Germany are 50 USD. I think i...
Hello, i think i have the same problem and discovered this :
How do i fix...
Thanks, but now you are confusing me.
The E3D is the stronger motor, so changing the Driver Board should be the better way...right ?
Here is the machine from EOS that printed my parts. (Test Prints)
Hello and thanks for the information.
I dont thought about the electronics, i simply bought the Titan Extruder and followed the instructions....
New photos online.
Hello, a friend of mine printed some test parts on a new prototype machine from EOS.
Photos updated ! (04-11-2021)
Hello, do you have STL file for the extruder plate ? Thank You.
First of all i replaced the hotend described in this post....
I'am really glad with the modifications of my R2.
With the massive help of this forum i changed Hotend and Extruder and what should i say....
My solution for the top.
Compete shutdown (Reset) ?
Check the Voltage or put an external power supply to thr Raspi.
After all, i dont think shut down the printer the hard way after printing is the problem, because the problem still exists.
Here are some things that i hope will help you.
(in the future ?)
I brought my fan shroud down with something like this.
(i think the better...
This is the first step to change the complete head. A first simple try and not complete. But it works fine on the R2. Will give you more...
Thermistor & Heater are 24V .
If the length is nearly the original you can use them.
Here are some things i have built in.
Thanks, motor support was one of the first things i printed.