1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Park A.
    Thread

    Hotend connectors?

    Hey guys, anyone know the nomenclature for the r2 stock hotend connectors? Micro JST? Molex, maybe? It's two separate two-pin connectors, but I'm...
    Thread by: Park A., Dec 21, 2017, 4 replies, in forum: General Questions
  2. Park A.
    Post

    Light...

    Ooohhh SNAP! I am made of questions right now. Maybe a new thread to talk about your experience with the palette+? Specifically about printing...
    Post by: Park A., Dec 20, 2017 in forum: Mods and Upgrades
  3. Park A.
    Profile Post

    makers gonna make

    makers gonna make
    Status update by Park A., Dec 20, 2017
  4. Park A.
    Post

    Light...

    The 24v power that you're tapping into on the main board. . . Isn't that intended to be used for the second extruder? (I guess I'm something of an...
    Post by: Park A., Dec 20, 2017 in forum: Mods and Upgrades
  5. Park A.
    Post

    BRAND NEW PRINTER Robo3d r2 temp readings

    You guys make up one of the best online communities I've ever known, so thanks for that. And thanks for all the help so far; I'm still having...
    Post by: Park A., Dec 20, 2017 in forum: Troubleshooting
  6. Park A.
    Post

    BRAND NEW PRINTER Robo3d r2 temp readings

    Unfortunately, I purchased through Robo3d directly. In other news, I've got another persistent error message now as well. Photo attached. I've...
    Post by: Park A., Dec 16, 2017 in forum: Troubleshooting
  7. Park A.
    Post

    BRAND NEW PRINTER Robo3d r2 temp readings

    UN.REAL... robo3d had single handedly induced a special kind of loathing for an activity I once thoroughly enjoyed. The mere thought of having to...
    Post by: Park A., Dec 16, 2017 in forum: Troubleshooting
  8. Park A.
    Thread

    BRAND NEW PRINTER Robo3d r2 temp readings

    I only emphasize the newness because this printer is one that was just sent to me to replace the r2 that I sent back to robo3d because it was...
    Thread by: Park A., Dec 16, 2017, 10 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 28 of 28
Search Again
Page 2 of 2