Separate names with a comma.
i am having trouble finding a 15 amp fuse holder that would fit where the 5 amp ptc fuse was. any suggestions as to where i can pick one up?
i think that is the spare port for the second hotend extruder
that looks interesting, ive actually emailed parts built a couple times through the website asking about the C2 main-board since it looks...
thank you Lance,
i have 3 more questions,
1. to the right of F1 and F2 there is the 12v aux but on the wiring diagram posted it says 24v, am...
im getting ready to do this mod and just going through the wiring before i start and there are a few areas that i am not quite following,...
i had this problem with the ribbon cable and it ended up being a small tear win the wiring below the ribbon connector
i don't remember having to use either one of those commands when i set up my r1, looks like its back to the tutorial page for me
Does the R2 Mesh setup work the same way as it does for the R1?