1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 9 of 9
  1. Avrution
    Post

    Solved Octoprint bed off?

    So, having it print outside the white outlines isn't going to be an issue? The printing isn't ending up centered. Left and right is fine, but up...
    Post by: Avrution, Nov 28, 2017 in forum: Troubleshooting
  2. Avrution
    Thread

    Solved Octoprint bed off?

    Sorry if this is too silly of a question, but after making sure the printer works correctly via USB with Mattercontrol I am now attempting to get...
    Thread by: Avrution, Nov 28, 2017, 6 replies, in forum: Troubleshooting
  3. Avrution
    Post

    Questions about Robo 3D R1+

    What upgrades might these be? Also, is there a way to tell the different revisions of the units? Rod never replied back after receiving the...
    Post by: Avrution, Nov 27, 2017 in forum: General Questions
  4. Avrution
    Post

    Raspberry pi config for Octoprint

    My R1 just arrived today as well as my Rpi3. Is Octoprint still going to be the best route for a remote print setup? This is going to be my...
    Post by: Avrution, Nov 27, 2017 in forum: General Questions
Find older messages
Showing results 161 to 164 of 164
Search Again
Page 9 of 9