1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Eric Viglotti
    Thread

    Partial Answer R1+ PEI Sheet?

    Hello, I was using an R1+ with just hairspray directly onto the glass until I put a bit too much on one day and shattered the glass. Not cool. So...
    Thread by: Eric Viglotti, Jan 4, 2018, 34 replies, in forum: General Questions
  2. Eric Viglotti
    Thread

    R2 PEI and Z-offset, I think

    I have had my R2 now for a few months after getting one of the first models and immediately I really beat up the PEI bed as I had no experience...
    Thread by: Eric Viglotti, Jan 2, 2018, 14 replies, in forum: Troubleshooting
  3. Eric Viglotti
    Thread

    Dimpling

    Hello, I have both an R1+ and an R2 and now I have had both printers exhibit this weird "dimpling" problem you see in this "Dimpling.jpeg" photo...
    Thread by: Eric Viglotti, Nov 25, 2017, 2 replies, in forum: Troubleshooting
  4. Eric Viglotti
    Thread

    Printing support like an R1+

    Hello, I have had an R1+ now for awhile and I am using an old Cura 15.04.6 per the suggestion of one of the Robo techs and it works well for many...
    Thread by: Eric Viglotti, Nov 7, 2017, 7 replies, in forum: Software
  5. Eric Viglotti
    Thread

    PETG for Robo R1+

    Hello, Have an R1+ and I have only used PLA, but I need to start using PETG. Anyone know: 1. How I create a command in the little LCD screen (in...
    Thread by: Eric Viglotti, Oct 2, 2017, 4 replies, in forum: General Questions
  6. Eric Viglotti
    Thread

    Melting PLA print when outside in sun

    Hello, I have been printing now for awhile and I noticed that my PLA prints do great indoors, but when I prime them and get them ready to keep...
    Thread by: Eric Viglotti, Aug 13, 2017, 34 replies, in forum: Off Topic
  7. Eric Viglotti
    Thread

    Octoprint/web interface folders

    Hello, I am using the Octoprint interface to access the R2 and I want to put my various uploaded files into folders. I clicked the "Create...
    Thread by: Eric Viglotti, Jul 25, 2017, 4 replies, in forum: General Questions
  8. Eric Viglotti
    Thread

    Maximum layer thickness

    I am using Cura with settings I got from Konrad and it's set to 0.2 as the default layer thickness for normal prints which is a good tradeoff...
    Thread by: Eric Viglotti, Feb 17, 2017, 10 replies, in forum: General Questions
Find older messages
Showing results 21 to 28 of 28
Search Again
Page 2 of 2