Separate names with a comma.
like no input on what number i should get?
do you recommend any specific drivers?
idk how but i think 3 of my drivers are dead. only two specific ones can be plugged in without it stalling the Arduino out
thats what i think it is i think its a bad driver lemme try
im back again for like the 20th time this week :( my problem this time is the new Arduino i completely stops responding when i have either the new...
think it was the RAMPS. and no i like to be stupid sometimes and tried it with the power on and felt the consequences of it. i swapped diver and...
nope not the ramps.
while trying to put the driver back in with plyers i think i killed the arduino..... im so pissed off with this POS right now.
thats what i thought imma cry if I have to replace the RAMPS because i cant find one that fits everything properly.
I try to print something and the extruder doesn't do anything. I try to do it in matter control and nothing. I looked and the wiring is correct....
welp i tryed the classic "turn it off and drain the caps and reboot" approach and it seems to be working. idek. I'm a comp sci major and...
how would i "shorten the y-axis because nothing is in the way.
i think i got it to kinda work. it homes well now but it moves the bed too far back when probing the z-axis before printing and i get grinding and...
ok so i got it to respond correctly. they are all "open". but the y is going the wrong way during the homing again :(
could be. whats your proposed fix?
I doubt that though because I checked it with my multimeter and it seems to be functioning correctly
y homes how it should but now when it SHOULD stop it keeps trying and makes a grinding noise
so normally closed I checked the switch connections and they are working somewhat fine.
also when I press the +y on matter control what way should...
i don't think so should it me normally closed?
also when I press the +y on matter control what way should the bed move?
whenever I try to home the y-axis it moves the opposite way its supposed to and makes a grinding noise
its the y. it goes the wrong way. and i flipped the wiring and it still does it