1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. JustinRF
    Thread

    Public Service Announcement for those with a 3rd party controller

    If any of you have a Robo 3D with an LCD controller or any other 3rd party controller with an SD card slot and use the SD card for more than 1...
    Thread by: JustinRF, Jul 14, 2016, 0 replies, in forum: Software
  2. JustinRF
    Post

    How To: Cura 15.04 Setup

    Huh, I could not find it before. Thank you though. I think I was searching the wrong thing
    Post by: JustinRF, Mar 25, 2016 in forum: Software
  3. JustinRF
    Post

    How To: Cura 15.04 Setup

    Hello, Does anyone happen to know the machine print head specifications? I want to do print one at a time mode but I cannot find those numbers.
    Post by: JustinRF, Mar 25, 2016 in forum: Software
  4. JustinRF
    Post

    Printing Printers

    ...so? How is she?
    Post by: JustinRF, Mar 13, 2016 in forum: Projects
  5. JustinRF
    Post

    Unanswered Quieter fans for the R1

    Thanks! I think I will do that!
    Post by: JustinRF, Feb 28, 2016 in forum: General Questions
  6. JustinRF
    Thread

    Unanswered Quieter fans for the R1

    Hey! I noticed, especially when I was with a friend who has a (much quieter) 3D printer, that the fans are excessively loud. Does anyone have...
    Thread by: JustinRF, Feb 28, 2016, 13 replies, in forum: General Questions
  7. JustinRF
    Post

    Touchscreen Controllers?

    Thanks, I will look into them. Haha, extruct. I may look into OctoPi/OctoPrint if it supports the Pi Zero. Whatevers cheaper
    Post by: JustinRF, Feb 4, 2016 in forum: General Questions
  8. JustinRF
    Thread

    Touchscreen Controllers?

    Hello! I was wondering if it is possible to get a touch controller installed onto the Robo. I know that you can buy a MatterControl Touch, however...
    Thread by: JustinRF, Feb 4, 2016, 31 replies, in forum: General Questions
  9. JustinRF
    Post

    Unresolved Bowden Extruder upgrade

    Where on Thingiverse is the one you have in the photo? Do you have a link? I am looking into doing this. I know this is technically a bump, but I...
    Post by: JustinRF, Jan 31, 2016 in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again