1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 10 of 10
  1. tkoco
    Post

    Z-Offset Wizard stuck at step 1 of 4

    When I need to activate the support option, the actual settings are model dependent. Some models only need the Touching Buildplate option while...
    Post by: tkoco, Apr 14, 2020 in forum: Troubleshooting
  2. tkoco
    Post

    ROBO R2 Installation

    If the print bed level is excellent, then auto level is not needed.
    Post by: tkoco, Apr 14, 2020 in forum: Germany
  3. tkoco
    Post

    bed crashes to nozzle always up after using z-offset wizard

    The firmware is old. I recommend upgrading to release Marlin 1,1,6_roboversion_1.2.6_R2.hex The link to the firmware is in the R2 FAQ along with...
    Post by: tkoco, Apr 14, 2020 in forum: Troubleshooting
  4. tkoco
    Post

    Z-Offset Wizard stuck at step 1 of 4

    My apologies. I am not following your thoughts on the question which you asked.
    Post by: tkoco, Apr 14, 2020 in forum: Troubleshooting
  5. tkoco
    Post

    where are the uploaded gcode files stored on the SD card?

    The Raspberry Pi Version 4 has 2 each USB 3 and I/O speed on those ports is excellent.
    Post by: tkoco, Apr 14, 2020 in forum: General Questions
  6. tkoco
    Post

    Filament FAQ

    For those of you using Cura, here is a GitHub site with some material files for Cura: https://github.com/Robo3D/fdm_materials If you wish to use...
    Post by: tkoco, Apr 13, 2020 in forum: Filament
  7. tkoco
    Post

    It started with a communication issue...

    1) Are you printing on Buildtak? 2) What temperature are you using for the filament ( in the quality profile in the Material(s) area )? 3) What...
    Post by: tkoco, Apr 13, 2020 in forum: Troubleshooting
  8. tkoco
    Post

    where are the uploaded gcode files stored on the SD card?

    The limiting factor could be the I/O access speed between the SDcard and the Raspberry Pi internals. A good article explaining the formatting on...
    Post by: tkoco, Apr 13, 2020 in forum: General Questions
  9. tkoco
    Post

    R2 FAQ

    More info on the red/black wire pair coming off of the Raspberry Pi GPIO bus connector; [ATTACH] That pair of wires go to the filament out...
    Post by: tkoco, Apr 13, 2020 in forum: Troubleshooting
  10. tkoco
    Post

    where are the uploaded gcode files stored on the SD card?

    Correct! Settings -> Octoprint -> Folders
    Post by: tkoco, Apr 12, 2020 in forum: General Questions
  11. tkoco
    Post

    moving backwards. need to start over.

    If the printer was powered off incorrectly, the software could develop a problem.
    Post by: tkoco, Apr 12, 2020 in forum: Troubleshooting
  12. tkoco
    Post

    PID calibration

    Problem is fixed. :)
    Post by: tkoco, Apr 12, 2020 in forum: Troubleshooting
Find older messages
Showing results 181 to 192 of 192
Search Again
Page 10 of 10