1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. janot928
    Post

    Just got my Robo 3d r1 plus yesterday Feb 18th. :)

    mine is still down.... upgrade they say it'll be easy, quick and cheap they say :/
    Post by: janot928, Feb 27, 2016 in forum: Show and Tell
  2. janot928
    Post

    Unanswered Z offset and filament stuck

    redneck way the best way :p
    Post by: janot928, Feb 27, 2016 in forum: Troubleshooting
  3. janot928
    Post

    Solved retract filiment

    heat up your extruder and then retract 10mm with the motor. The rest you should be able to take the rest out by hand
    Post by: janot928, Feb 27, 2016 in forum: Troubleshooting
  4. janot928
    Post

    Unresolved Smooth printing on half the part

    also i forgot, but also try to lower the printing temperature if the retraction settings doesn't work
    Post by: janot928, Feb 27, 2016 in forum: Troubleshooting
  5. janot928
    Post

    Unresolved how to I get at the thermister

    [MEDIA]
    Post by: janot928, Feb 22, 2016 in forum: Troubleshooting
  6. janot928
    Post

    Unresolved how to I get at the thermister

    i havent used this one in a while but from memory: -slightly unscrew the heater cartridge screw -remove the heater cartridge -remove the black...
    Post by: janot928, Feb 22, 2016 in forum: Troubleshooting
  7. janot928
    Post

    Unresolved Smooth printing on half the part

    for the stringing part : -put a 3 mm retract on the filament, -activate the option of "not crossing the perimeter" and for the assymetry try and...
    Post by: janot928, Feb 22, 2016 in forum: Troubleshooting
  8. janot928
    Post

    Unresolved how to I get at the thermister

    I suppose you are using the default exagon hot end ? if not sure please add a photograph of your hot-end
    Post by: janot928, Feb 22, 2016 in forum: Troubleshooting
Find older messages
Showing results 21 to 28 of 28
Search Again
Page 2 of 2