1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 3 of 3
  1. Jutte
    Thread

    PLA Wood Filament

    Not sure just what I expected, but I'm not terribly impressed with the wood filament. It's brown but beyond that it just looks like PLA. What...
    Thread by: Jutte, Apr 23, 2016, 17 replies, in forum: Printing Filament
  2. Jutte
    Thread

    Smooth Operator

    One week in on my refurbished Robo R1, I am impressed with the relatively low noise level compared to my Cube 3. While the Cube 3 sounds like a...
    Thread by: Jutte, Apr 19, 2016, 0 replies, in forum: General Questions
  3. Jutte
    Post

    Solved Disconnected cable

    Thanks all. I took a closer look and got it sorted out. The wires on that side must have gotten dislodged, back in place now.
    Post by: Jutte, Apr 13, 2016 in forum: Troubleshooting
  4. Jutte
    Post

    Hello from central Florida

    Thank you all! Finally found where to adjust the z offset in Matter Control. Will try again tomorrow.
    Post by: Jutte, Apr 12, 2016 in forum: United States of America
  5. Jutte
    Post

    Solved Disconnected cable

    There is nothing connected to the left limit switch. The right limit switch is wired.
    Post by: Jutte, Apr 12, 2016 in forum: Troubleshooting
  6. Jutte
    Thread

    Solved Disconnected cable

    I just discovered a cable that was sitting at the left side unconnected to anything. I have been printing and had no issues other than filament...
    Thread by: Jutte, Apr 12, 2016, 4 replies, in forum: Troubleshooting
  7. Jutte
    Thread

    Hello from central Florida

    I'm a relative novice to 3d printing. My first printer was a Cube 3 which I still love, but it has limitations and has been discontinued. I...
    Thread by: Jutte, Apr 12, 2016, 4 replies, in forum: United States of America
Find older messages
Showing results 41 to 47 of 47
Search Again
Page 3 of 3