1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Rascal
    Post

    PolyCarb and Bridge Nylon.

    Taulman Bridge : http://taulman3d.com/bridge-features.html
    Post by: Rascal, Apr 29, 2016 in forum: Printing Filament
  2. Rascal
    Post

    PolyCarb and Bridge Nylon.

    Mark, I tried the Nylon and got about 3 mm of solid fill before the ugly warp on the edges made me cancel .. ugh. I swapped in my carbron fiber...
    Post by: Rascal, Apr 29, 2016 in forum: Printing Filament
  3. Rascal
    Post

    PolyCarb and Bridge Nylon.

    Okay, Thanks. I am in process of boring out the carriage for the V6 upgrade, Then I will design a bracket for the Titan and reassemble and print...
    Post by: Rascal, Apr 29, 2016 in forum: Printing Filament
  4. Rascal
    Post

    PolyCarb and Bridge Nylon.

    You mentioned dialing in the settings, I was going to use the suggested settings from reprap, but if there are any other settings I should know of...
    Post by: Rascal, Apr 29, 2016 in forum: Printing Filament
  5. Rascal
    Post

    PolyCarb and Bridge Nylon.

    Mark, Are you saying that the 6 pin is fine to go up to 120C or do I need to throw in some high current capable connectors in anyway? Also, do you...
    Post by: Rascal, Apr 28, 2016 in forum: Printing Filament
  6. Rascal
    Post

    PolyCarb and Bridge Nylon.

    I will look into it... I already bought the poly...
    Post by: Rascal, Apr 28, 2016 in forum: Printing Filament
  7. Rascal
    Post

    PolyCarb and Bridge Nylon.

    Okay, thank you all. I am hoping to use it since it very strong and heat resistant.
    Post by: Rascal, Apr 28, 2016 in forum: Printing Filament
  8. Rascal
    Post

    E3D Titan Extruder

    Do you need to mod the settings for the light nema 17s or are they the same? I am noobin into this. I have to take it all apart to figure out my...
    Post by: Rascal, Apr 26, 2016 in forum: Mods and Upgrades
  9. Rascal
    Post

    E3D Titan Extruder

    Dont want to sound like a moron, but... what is wrong with the original motor? Other than orientation.
    Post by: Rascal, Apr 26, 2016 in forum: Mods and Upgrades
  10. Rascal
    Post

    PolyCarb and Bridge Nylon.

    Were you using the stock bed? Mine cuts at 85 I think. Is it thermally safe to go higher? I read on the manufacturer website to use glue and a...
    Post by: Rascal, Apr 26, 2016 in forum: Printing Filament
  11. Rascal
    Thread

    PolyCarb and Bridge Nylon.

    Has anyone had success printing either of these on the R1 plus 80 Deg bed? If so what did you use? I am going to attempt 3M 77 adhesive after my...
    Thread by: Rascal, Apr 25, 2016, 30 replies, in forum: Printing Filament
Find older messages
Showing results 21 to 31 of 31
Search Again
Page 2 of 2