1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Aaron Lunger
    Post

    Solved Robo3D R1 Plus frozen

    Well, I can try that tonight and hope that that fixes the problem. If not, I guess it's time for a new RAMPS. And a few rolls of filament. Hah!
    Post by: Aaron Lunger, Sep 28, 2017 in forum: Troubleshooting
  2. Aaron Lunger
    Post

    Solved Robo3D R1 Plus frozen

    If it's just the arduino mega, could I use any Arduino Mega 256 (once loaded with the updated firmware of course......)? I already have one of...
    Post by: Aaron Lunger, Sep 28, 2017 in forum: Troubleshooting
  3. Aaron Lunger
    Post

    Solved Robo3D R1 Plus frozen

    Is this pretty much same as what's in the Robo already? Just trying to decide if that's the best route to go at this point. Could it be the RAMPS...
    Post by: Aaron Lunger, Sep 28, 2017 in forum: Troubleshooting
  4. Aaron Lunger
    Post

    Solved Robo3D R1 Plus frozen

    USB. Have been since I got the printer (ie about 2 years maybe?) I really hope not. This has happened about 4 or so times now during my 40 hour...
    Post by: Aaron Lunger, Sep 28, 2017 in forum: Troubleshooting
  5. Aaron Lunger
    Thread

    Solved Robo3D R1 Plus frozen

    I've got a Robo 3D R1 Plus, with the LCD mod. The printer has been working for months like this. Zero issues or problems printing. Lately now,...
    Thread by: Aaron Lunger, Sep 28, 2017, 14 replies, in forum: Troubleshooting
  6. Aaron Lunger
    Post

    Answered Lack of parts and support with Robo

    Oh, I'm very well aware of how support goes. Having a fully modded XYZ Printing Da Vinci (E3D V6 hotend, new carrier, hardened steel shafts, E3D...
    Post by: Aaron Lunger, Dec 16, 2016 in forum: General Questions
  7. Aaron Lunger
    Post

    Answered Lack of parts and support with Robo

    Personally, I love the printer. It's much better than my previous XYZ Printing machine..... However....while XYZ's support was lacking, at least...
    Post by: Aaron Lunger, Dec 16, 2016 in forum: General Questions
Find older messages
Showing results 21 to 27 of 27
Search Again
Page 2 of 2