1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. Barry Steenbergh
    Post

    Solved Robo3D R1 smoke out back and wont power up

    I own an Arduino Uno so that would be an inexpensive fix if that is my problem. :) The magic white smoke jetted out from the backside of my...
    Post by: Barry Steenbergh, Jan 28, 2017 in forum: Troubleshooting
  2. Barry Steenbergh
    Post

    Solved Robo3D R1 smoke out back and wont power up

    Robert: LOL. yeah I thought the same thing. :( So if I have 12 volts across the +V and -V my power supply is ok? Any suggestions on where/how...
    Post by: Barry Steenbergh, Jan 28, 2017 in forum: Troubleshooting
  3. Barry Steenbergh
    Post

    Solved Robo3D R1 smoke out back and wont power up

    Hi All, My power supply definitely looks different than the one above.. (Sorry, not my best photography work..) [ATTACH] If all three +V...
    Post by: Barry Steenbergh, Jan 26, 2017 in forum: Troubleshooting
  4. Barry Steenbergh
    Post

    Solved Robo3D R1 smoke out back and wont power up

    Hey Mark, Looking at the power supply I see nine terminal. The Leftmost 3 have a "+V" the middle 3 have "-V" and the right three have (Ground) N...
    Post by: Barry Steenbergh, Jan 24, 2017 in forum: Troubleshooting
  5. Barry Steenbergh
    Post

    Solved Robo3D R1 smoke out back and wont power up

    Thanks, Mark! I'm hopeful that I will be able to get it going. :-) --Barry
    Post by: Barry Steenbergh, Jan 23, 2017 in forum: Troubleshooting
  6. Barry Steenbergh
    Post

    Solved Robo3D R1 smoke out back and wont power up

    I see 12v on the Red/green but not on Red/Black pairs. I do see a green LED lit near the middle of the printer but I'm not sure if there was an...
    Post by: Barry Steenbergh, Jan 23, 2017 in forum: Troubleshooting
  7. Barry Steenbergh
    Thread

    Solved Robo3D R1 smoke out back and wont power up

    Hi All, Just purchased a slightly used Robo3D R1 from a coworker who had owned it for a couple years but only made 4 prints on it. (Still have...
    Thread by: Barry Steenbergh, Jan 23, 2017, 26 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 27 of 27
Search Again
Page 2 of 2