1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. 2brosmanufacturing
    Post

    Unresolved Bad Ramps board, motor or both?

    well I had a few mins this morning to mess around with it and was swapping around the cards and that did nothing for the issue. I did try the...
    Post by: 2brosmanufacturing, Feb 16, 2016 in forum: Troubleshooting
  2. 2brosmanufacturing
    Thread

    Unresolved Bad Ramps board, motor or both?

    Was running a print and the extruded started making horrible noises, stopped the print and checked it out, pulled the gears off to make sure...
    Thread by: 2brosmanufacturing, Feb 15, 2016, 2 replies, in forum: Troubleshooting
  3. 2brosmanufacturing
    Post

    Solved Extruder stepper motor Stuck

    I just had the same issue with my r1 plus, half way through a print and it sounded like the gears where stripping, took the gears off and the...
    Post by: 2brosmanufacturing, Feb 15, 2016 in forum: Troubleshooting
  4. 2brosmanufacturing
    Post

    E3d volcano

    So for doing larger parts it would be good but probably not for alot of the smaller parts.
    Post by: 2brosmanufacturing, Feb 14, 2016 in forum: General Questions
  5. 2brosmanufacturing
    Thread

    E3d volcano

    Went and looked at another robo to sell to my brother to replace is prusa i3. Came with then e3d v6 and xxl along with a spare v6, and the...
    Thread by: 2brosmanufacturing, Feb 13, 2016, 3 replies, in forum: General Questions
  6. 2brosmanufacturing
    Thread

    Unresolved Extruder runs reverse on print start, sometimes

    Once in a while and seems to be happening more frequently, the extruder runs full on in reverse forcing the filament back up and the head just...
    Thread by: 2brosmanufacturing, Feb 8, 2016, 1 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again