1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Adam Thompson
    Post

    Solved Extruder wont turn on and lead screw skips (board issue?)

    Using the link you sent me, the voltage numbers and tutorial from...
    Post by: Adam Thompson, Sep 4, 2021 in forum: Troubleshooting
  2. Adam Thompson
    Post

    Solved Extruder wont turn on and lead screw skips (board issue?)

    I ordered a multimeter and then replacement drivers and boards through a bundle you had recommended a long time ago to another person, except...
    Post by: Adam Thompson, Sep 3, 2021 in forum: Troubleshooting
  3. Adam Thompson
    Post

    Solved Extruder wont turn on and lead screw skips (board issue?)

    Thank you! I will let you know how it goes later today
    Post by: Adam Thompson, Sep 3, 2021 in forum: Troubleshooting
  4. Adam Thompson
    Post

    Solved Extruder wont turn on and lead screw skips (board issue?)

    Thank you. After trying the extruder with heat, it works. I guess there small amount of junk i cleaned out of the bearings fixed the issue (or I...
    Post by: Adam Thompson, Sep 3, 2021 in forum: Troubleshooting
  5. Adam Thompson
    Post

    Solved Extruder wont turn on and lead screw skips (board issue?)

    shoot, i was running the extruder without heat. I will have to switch out the driver on the leadscrew and see if that fixes that. I may be a few...
    Post by: Adam Thompson, Sep 1, 2021 in forum: Troubleshooting
  6. Adam Thompson
    Thread

    Solved Extruder wont turn on and lead screw skips (board issue?)

    Hello, I initial had some grinding noise coming from the extruder motor from my last print. Now it will not turn at all. In addition to this the...
    Thread by: Adam Thompson, Sep 1, 2021, 11 replies, in forum: Troubleshooting
  7. Adam Thompson
    Post

    Partially Solved 2nd Layer not sticking to 1st layer (PLA).....

    Well this helped a lot. Thank goodness for old forums. After a few hours of tweaking I nearly lost my mind when my PLA started printing as if it...
    Post by: Adam Thompson, Aug 2, 2019 in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again