1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Jason Bates
    Post

    Chimera Upgrade Guide (WIP)

    Yeah neither of them work Sent from my SM-G955U using Tapatalk
    Post by: Jason Bates, Feb 22, 2018 in forum: Mods and Upgrades
  2. Jason Bates
    Post

    Chimera Upgrade Guide (WIP)

    I am trying to do this upgrade on my R1+ and have became stuck :( I installed the new ramps 1.4 board, and installed the new driver. The chimera...
    Post by: Jason Bates, Feb 22, 2018 in forum: Mods and Upgrades
  3. Jason Bates
    Post

    Dual extruder upgrade issue

    attached is my config.h
    Post by: Jason Bates, Feb 7, 2018 in forum: Mods and Upgrades
  4. Jason Bates
    Post

    Dual extruder upgrade issue

    Sorry I'll post my config.h file when I get off work. I know is switched motherboard to 34 and changed extruders to 2. Sent from my SM-G955U...
    Post by: Jason Bates, Feb 7, 2018 in forum: Mods and Upgrades
  5. Jason Bates
    Thread

    Dual extruder upgrade issue

    So I have the wiring with the new ramps 1.4 board. The 5 drivers. The hotends and bed heat up correctly. The 2 extruders I mounted on the side of...
    Thread by: Jason Bates, Feb 6, 2018, 4 replies, in forum: Mods and Upgrades
  6. Jason Bates
    Thread

    Answered Robo r1+ hot end fan

    Well my hot end fan stopped working on me while he of course caused a major clog. I have put in an order for a replacement fan but they are not in...
    Thread by: Jason Bates, Feb 20, 2017, 1 replies, in forum: Troubleshooting
  7. Jason Bates
    Thread

    Unanswered Z offset and filament stuck

    i have had my robo r1 plus for over a month now and it has been printing like a champ until tonight. I am printing with pla btw. The printer homes...
    Thread by: Jason Bates, Feb 26, 2016, 10 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again