1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Nicola Gibson
    Post

    Solved Extruder Stepper not responding

    Thank you very much Mark That’s really helpful It’s working again at the moment so I will let sleeping dogs lie for now and use your check list...
    Post by: Nicola Gibson, Apr 3, 2018 in forum: Troubleshooting
  2. Nicola Gibson
    Thread

    Solved Extruder Stepper not responding

    Hello I spent yesterday rewiring my print bed heater because it stopped working a while ago. I have a pretty old Robo - I think it's the one...
    Thread by: Nicola Gibson, Apr 3, 2018, 4 replies, in forum: Troubleshooting
  3. Nicola Gibson
    Post

    Answered Bed not heating

    Hello again - Just a quick up date I've loosen everything, cleaned, lubricated and re-tightened. It's all feeling much better. Fingers crossed....
    Post by: Nicola Gibson, Oct 24, 2017 in forum: Troubleshooting
  4. Nicola Gibson
    Post

    Answered Bed not heating

    Thank you both - typically (although I am pleased) after some poking about it fired into life. I don't know how long for but I think that suggests...
    Post by: Nicola Gibson, Oct 23, 2017 in forum: Troubleshooting
  5. Nicola Gibson
    Thread

    Answered Bed not heating

    Hi I have been reading about replacing the ramps board as my heatbed has stopped working. Im reasonably sure the thermistor is fine because it's...
    Thread by: Nicola Gibson, Oct 22, 2017, 5 replies, in forum: Troubleshooting
  6. Nicola Gibson
    Post

    Solved Y axis end stop

    Okay- I checked my end stop and that responds fine- what's happening is that it is travelling too far forward, or trying to. This is when I auto...
    Post by: Nicola Gibson, Jul 27, 2016 in forum: Troubleshooting
  7. Nicola Gibson
    Thread

    Solved Y axis end stop

    Hi I have just fitted a new v6 hot end. So, that was okay and I printed up a couple of bits before getting a temp fall error. I tightened...
    Thread by: Nicola Gibson, Jul 27, 2016, 1 replies, in forum: Troubleshooting
  8. Nicola Gibson
    Thread

    Netfabb access violation

    Hello! Just to outline where I'm up to, I've only been using my printer for a couple of months or so and it's wonderful! I love it. I have started...
    Thread by: Nicola Gibson, Apr 22, 2016, 1 replies, in forum: Software
Showing results 1 to 8 of 8
Search Again