1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Paul Arnold
    Thread

    Partial Answer Why so flaky?

    Ya'll are getting to know me as I've been posting quite a bit lately. I've had my Robo R1+ for two years and have had very few problems with it....
    Thread by: Paul Arnold, Feb 18, 2018, 19 replies, in forum: Troubleshooting
  2. Paul Arnold
    Thread

    Solved Hot End smoking, software reads 136 degrees

    I have two different hot ends and the both smoke when I run the printer. Matter control, Cura, and S3d all report the extruder temp at 135...
    Thread by: Paul Arnold, Feb 16, 2018, 9 replies, in forum: Troubleshooting
  3. Paul Arnold
    Thread

    Solved Filament only extrudes with matter control

    I've been using Matter Control, Cura, and Simplify 3D. All with success, but I find different models may print better with one over the other....
    Thread by: Paul Arnold, Feb 12, 2018, 3 replies, in forum: Troubleshooting
  4. Paul Arnold
    Thread

    Solved Extruder jambing - not clogging

    I've have successfully printed hundreds of things, gone through probably 20 spools of PLA so far, and I've had little issues here and there, but...
    Thread by: Paul Arnold, Feb 7, 2018, 18 replies, in forum: Troubleshooting
  5. Paul Arnold
    Thread

    Solved Bed noise during self leveling

    A few weeks ago this problem started, right around the time I purchased Simplify 3D. When the printer goes through it's self leveling, and the...
    Thread by: Paul Arnold, Jan 31, 2018, 5 replies, in forum: Troubleshooting
  6. Paul Arnold
    Thread

    Answered Worn nozzle, is this possible?

    My friend recently purchased, at my urging, a refurbished Robo 3D from here. Pictured on the left is a barely used nozzle from my Robo 3D and on...
    Thread by: Paul Arnold, Mar 1, 2017, 5 replies, in forum: Troubleshooting
  7. Paul Arnold
    Thread

    Solved Prints are blobbing with burnt spots of plastic

    I just repaired a major clogging issue, which was caused by the fan on the cooling fins of the cold side of the extruder assembly. Now that I am...
    Thread by: Paul Arnold, Feb 10, 2017, 9 replies, in forum: Troubleshooting
  8. Paul Arnold
    Thread

    Solved First layer bubbling

    I have reviewed the visual trouble shooting guide, and don't find this issue. This is the bottom of mt print. Bed temp is 200 and head temp is...
    Thread by: Paul Arnold, Dec 30, 2016, 1 replies, in forum: Troubleshooting
  9. Paul Arnold
    Thread

    Solved Uneven bed temps, is this normal

    I am posting a picture of my bed, with temps in Celsius measured at 11 different points, with my bed temp setting at 60. Also green dots indicate...
    Thread by: Paul Arnold, Mar 22, 2016, 3 replies, in forum: Troubleshooting
  10. Paul Arnold
    Thread

    Solved Bubbling on bed, where do I start?

    My first several attempts at printing with the supplied blue PLA went pretty close to perfect. I replaced the PLA with some Gizmo Dorks Wood PLA,...
    Thread by: Paul Arnold, Mar 15, 2016, 6 replies, in forum: Troubleshooting
Showing results 1 to 10 of 10
Search Again