1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. D Wiley
    Post

    Solved Hotend cooling issues?

    I don't know if "Solved" is correct or not, but things are working fine for now. It may have been a combination of things that were causing...
    Post by: D Wiley, Aug 30, 2017 in forum: Troubleshooting
  2. D Wiley
    Post

    Solved Hotend cooling issues?

    This is with ABS, but no, I have never needed to before. Things have always flowed smoothly. I guess I can try a run with PLA just for the fun...
    Post by: D Wiley, Aug 29, 2017 in forum: Troubleshooting
  3. D Wiley
    Post

    Solved Hotend cooling issues?

    Fan is installed correctly and I still seem to be having the same problem. I have tried varying levels of tension on the extruder, as I may have...
    Post by: D Wiley, Aug 29, 2017 in forum: Troubleshooting
  4. D Wiley
    Post

    Solved Hotend cooling issues?

    Ah...Ok then... I must have reversed it when I took the original off to try cleaning out... I guess while I have more of it taken apart, I will...
    Post by: D Wiley, Aug 28, 2017 in forum: Troubleshooting
  5. D Wiley
    Post

    Solved Hotend cooling issues?

    I am almost certain I have it in the same orientation as the original. I assume it blows away from the hotend rather than towards it?
    Post by: D Wiley, Aug 28, 2017 in forum: Troubleshooting
  6. D Wiley
    Post

    Solved Hotend cooling issues?

    That was was what I assumed, so I have replaced that fan but it did not solve the issue. I'll dismantle things a bit further so that I can get to...
    Post by: D Wiley, Aug 28, 2017 in forum: Troubleshooting
  7. D Wiley
    Thread

    Solved Hotend cooling issues?

    I have run my R1 for many hours with out problems, but recently I have had problems extruding which seem to be caused by the heat from the hotend...
    Thread by: D Wiley, Aug 28, 2017, 14 replies, in forum: Troubleshooting
  8. D Wiley
    Post

    Unanswered X axis not homing properly

    Found the problem, at least with my equipment... I pulled out the switch, did some testing on the terminals including some peak resistance checks...
    Post by: D Wiley, Mar 25, 2016 in forum: Troubleshooting
  9. D Wiley
    Post

    Unanswered X axis not homing properly

    I have been having the same problem in the last few days and finally decided today to try to get things up and running again...Before finding this...
    Post by: D Wiley, Mar 25, 2016 in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again