1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. cybershipley
    Thread

    Unresolved Excessive Bed Flex On Left Side

    I have 2 Robo3d R1+ printers at work. One of them works just fine, but for the other one... I have never been able to get the bed leveling...
    Thread by: cybershipley, Jul 14, 2016, 19 replies, in forum: Troubleshooting
  2. cybershipley
    Thread

    Solved Quick Question About Z Axis Brass Nuts

    Sorry if this has been answered previously, but what's the easiest way to adjust the position of the z axis brass nuts? For me they are not close,...
    Thread by: cybershipley, Jul 7, 2016, 2 replies, in forum: Troubleshooting
  3. cybershipley
    Thread

    Solved M3 Stud Thermistor Question

    Before installing the e3dv6 and stud thermistor I could heat my hot end up to at least 285C, but now I can only go to about 250C. Is there a...
    Thread by: cybershipley, Jul 2, 2016, 26 replies, in forum: Troubleshooting
  4. cybershipley
    Thread

    Solved Extruder clicking in one spot

    I did the e3dv6 upgrade, but now I hear clicking (skipping steps). It only happens in one place as I turn the extrusion wheel manually. It gets...
    Thread by: cybershipley, Jun 16, 2016, 2 replies, in forum: Troubleshooting
  5. cybershipley
    Thread

    Unanswered Autoleveling using cura

    I have 15.04.06 and I have managed to get it working and print. However, it's not doing the 9 point bed leveling like in Mattercontrol. Any...
    Thread by: cybershipley, May 26, 2016, 43 replies, in forum: Troubleshooting
  6. cybershipley
    Thread

    Best and Easiest To Use Flexible Filament

    Hi everyone. I've had my Robo3D printer for about a month now. It seems to work great. Previously had a Cube3 which was horrible imho. This is...
    Thread by: cybershipley, Mar 25, 2016, 11 replies, in forum: Printing Filament
Showing results 1 to 6 of 6
Search Again