1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. thomas49065
    Thread

    Solved Robo 3D R1+ for sale

    Little over 1.5 years old upgraded to the E3D volcano with one part cooling fan. Comes with extra parts (ramps,2 heating elements for bed,...
    Thread by: thomas49065, Jun 15, 2017, 14 replies, in forum: General Questions
  2. thomas49065
    Thread

    Unresolved Bed heating issues again

    Hello, It has been a year now and things have been clicking along nicely with the R1+ since the bed stopped heating a year ago. Now it wont heat...
    Thread by: thomas49065, Mar 24, 2017, 2 replies, in forum: Troubleshooting
  3. thomas49065
    Thread

    Answered R+ heat bed stopped heating

    My bed has been intermittently heating well the other day during printing I smelled burning wire casing. Wont heat now opened case one red 12...
    Thread by: thomas49065, May 9, 2016, 4 replies, in forum: Troubleshooting
  4. thomas49065
    Thread

    Solved Partial hot end obstruction?

    Robo 3d r1+ stock hot end. Was running a 17hour PLA print and about hour 10 started getting terrible under-fill and the filament was stripped....
    Thread by: thomas49065, May 9, 2016, 7 replies, in forum: Troubleshooting
  5. thomas49065
    Thread

    Unanswered R1+ max bed temp

    I keep getting max bed temp error at 110C is that correct I was under the impression the r1+ would perform at higher temps then that.
    Thread by: thomas49065, Apr 23, 2016, 3 replies, in forum: Troubleshooting
  6. thomas49065
    Thread

    Unresolved R+ heat bed stopped heating

    I have a R1+ I purchased just over a month ago. Decided to finally take on ABS yesterday and apparently from what I have read I was running the...
    Thread by: thomas49065, Apr 15, 2016, 13 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again