1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. RD Ghost
    Thread

    Partially Solved X Belt help.

    I had to replace my X belt with a non loop belt what's the best way to reattach it.
    Thread by: RD Ghost, May 14, 2018, 14 replies, in forum: Troubleshooting
  2. RD Ghost
    Thread

    Solved ROBO R1+ Bed Leveling

    I don't understand I am using the v2 Firmware from the ROBO website with Simplify3D. Auto level never works now one side tow low the other to...
    Thread by: RD Ghost, Jul 6, 2017, 11 replies, in forum: Troubleshooting
  3. RD Ghost
    Thread

    Answered Need new hotend.

    Robo is sold out of their hotend is this the same Rep Rap Hexagon? I can't print a any new parts so I need one that will fit without modifying...
    Thread by: RD Ghost, Nov 1, 2016, 55 replies, in forum: Troubleshooting
  4. RD Ghost
    Thread

    Solved PLA & Blue Painters Tape

    I have started using blue painters tape to prevent my bed from chipping I have gone through two glass beds. I Have printed PETG on the tape but my...
    Thread by: RD Ghost, Aug 11, 2016, 10 replies, in forum: Troubleshooting
  5. RD Ghost
    Thread

    Solved Wires on board keep coming loose

    So every 4th or 5th print I have to take the bottom off of my printer and push in wires on the board that have come loose. I was wondering if it...
    Thread by: RD Ghost, Jun 14, 2016, 10 replies, in forum: Troubleshooting
  6. RD Ghost
    Thread

    Solved Quick Release Pull Tab Trouble.

    I have to pry that Quick Release Pull Tab out with a flat head screw driver because I cant loosen the Quick Release Screw. I think the Nut for...
    Thread by: RD Ghost, May 5, 2016, 4 replies, in forum: Troubleshooting
  7. RD Ghost
    Thread

    Answered Small print probably

    I am getting gaps on small parts with curved tops. I would love some advice on this. Also if you have advice or tips for small prints on a robo.
    Thread by: RD Ghost, Apr 30, 2016, 6 replies, in forum: Troubleshooting
  8. RD Ghost
    Thread

    Delete

    Delete.
    Thread by: RD Ghost, Apr 8, 2016, 0 replies, in forum: Software
Showing results 1 to 8 of 8
Search Again