1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. TomerO
    Thread

    Marlin 1.1.9 for Robo3D R1+ & Fan speed hotend temp protection

    Hello everyone :) I recently finished updating my printer to 1.1.9 (decided not to go for 2.0 for now). Since my code is in github I thought it...
    Thread by: TomerO, Nov 11, 2019, 1 replies, in forum: Mods and Upgrades
  2. TomerO
    Thread

    Gradually increasing fan speed #marlin

    Background (to why I did this, you can skip this and go to the next section if you want): Since I upgraded to E3D v6 and change the fan ducts to...
    Thread by: TomerO, Jul 5, 2016, 0 replies, in forum: Mods and Upgrades
  3. TomerO
    Thread

    Hello from Israel

    Hey everyone! My name is Tomer and I own a Robo3d R1+ for about 7 months now. The appearance of a good community is one of the main things that...
    Thread by: TomerO, Jun 14, 2016, 2 replies, in forum: Introduction
  4. TomerO
    Thread

    Build plate holder

    I have created a small holder to hold my polycarbonate build plate and allow me to easily apply and remove it whenever I want. This is not fully...
    Thread by: TomerO, Jun 13, 2016, 0 replies, in forum: Mods and Upgrades
  5. TomerO
    Thread

    Unanswered Brittle Filament

    Hey, It is nothing new, but I decided it is time to maybe address this issue. Some of my filament rolls (all eSun PLA) tend to break when sitting...
    Thread by: TomerO, Jun 7, 2016, 12 replies, in forum: Troubleshooting
  6. TomerO
    Thread

    Serial through raspberry pi

    (Note: I'm mainly sharing what I did, no time to actually upload the stuff now + question at the end) Hey guys, I am recently working (mainly for...
    Thread by: TomerO, Jun 5, 2016, 3 replies, in forum: Software
  7. TomerO
    Thread

    S3D + Octopi automation

    Hey guys, After a lot of time I only used other people's resources I decided its time to start sharing some =] This is nothing big, just a python...
    Thread by: TomerO, May 7, 2016, 0 replies, in forum: Software
Showing results 1 to 7 of 7
Search Again