1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Miguel Angel
    Post

    Unanswered I think I am losing steps on Z axis.

    So yesterday I got the drivers for the stepper motors. I removed the Z axis driver and found it smelled funny like smoke. I calibrated the new...
    Post by: Miguel Angel, May 6, 2016 in forum: Troubleshooting
  2. Miguel Angel
    Post

    Unanswered I think I am losing steps on Z axis.

    Cool thanks a lot I have some homework to do! I will let you know what happens! :)
    Post by: Miguel Angel, May 4, 2016 in forum: Troubleshooting
  3. Miguel Angel
    Post

    Unanswered I think I am losing steps on Z axis.

    Ok I am guessing that they can be replaced. Where could I get such a replacement?
    Post by: Miguel Angel, May 4, 2016 in forum: Troubleshooting
  4. Miguel Angel
    Post

    Unanswered I think I am losing steps on Z axis.

    Yes they have the aluminum couplers. So you think it has to do with the ARDUINO + RAMPS SHEILD 1.4 FULL ELECTRONICS CONTROL BOARD?
    Post by: Miguel Angel, May 4, 2016 in forum: Troubleshooting
  5. Miguel Angel
    Post

    Unanswered I think I am losing steps on Z axis.

    Ok I was not able to communicate with the Arduino Mega 2560this to see the current settings. So opted to upload a new firmware to the arduino with...
    Post by: Miguel Angel, May 4, 2016 in forum: Troubleshooting
  6. Miguel Angel
    Post

    Unanswered I think I am losing steps on Z axis.

    Yes it does it both on Cura and Matter Control. Actually now it starting to make a clunky sound coming from the stepper motor. When you refer to...
    Post by: Miguel Angel, May 4, 2016 in forum: Troubleshooting
  7. Miguel Angel
    Post

    Unanswered I think I am losing steps on Z axis.

    R1
    Post by: Miguel Angel, May 4, 2016 in forum: Troubleshooting
  8. Miguel Angel
    Post

    Unanswered I think I am losing steps on Z axis.

    Update on the issue. Currently I am having the same trouble with CURA. I think the problem may be hardware related.
    Post by: Miguel Angel, May 4, 2016 in forum: Troubleshooting
  9. Miguel Angel
    Thread

    Unanswered I think I am losing steps on Z axis.

    I love mattercontrol and my Robo3. It has been 1 year of non stop printing. Recently I have been having issues with the prints. It seem the...
    Thread by: Miguel Angel, May 3, 2016, 30 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again