1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. alexhartwig02
    Post

    Solved R1+ ABS stops extruding.

    Well had some warping but the print actually finished. Print took 14hrs and didn't clog. I'm hoping it cured it and not just a lucky break....
    Post by: alexhartwig02, May 22, 2016 in forum: Troubleshooting
  2. alexhartwig02
    Post

    Solved R1+ ABS stops extruding.

    I measured several feet of the filament and it measures all right. Clean the hobbled bolt. Yes I am using MatterControl. The extruder is very...
    Post by: alexhartwig02, May 22, 2016 in forum: Troubleshooting
  3. alexhartwig02
    Post

    Solved R1+ ABS stops extruding.

    Okay ill have to check on that. If its good filament what should i try next? If its bad I'll change it out.
    Post by: alexhartwig02, May 19, 2016 in forum: Troubleshooting
  4. alexhartwig02
    Post

    Solved R1+ ABS stops extruding.

    No i haven't tried a different brand of filament. The temperature doesnt fluctuate too wildly. Usually within a degree or two of my setting. All...
    Post by: alexhartwig02, May 19, 2016 in forum: Troubleshooting
  5. alexhartwig02
    Post

    Solved R1+ ABS stops extruding.

    Filament size is 1.75 and the hotend is the standard all metal hexagon
    Post by: alexhartwig02, May 19, 2016 in forum: Troubleshooting
  6. alexhartwig02
    Post

    Solved R1+ ABS stops extruding.

    260 degrees. Adjusted from ranges of 250-280 in 5 degree increments. Speeds are below 80. It never clogs. It just usually takes me to unload it,...
    Post by: alexhartwig02, May 19, 2016 in forum: Troubleshooting
  7. alexhartwig02
    Thread

    Solved R1+ ABS stops extruding.

    During larger prints only, several hours of printing the filament will stop extruding and it will just stop at grind away at the gears. I have...
    Thread by: alexhartwig02, May 19, 2016, 20 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again