1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Mark Howe
    Post

    Solved only 7 points make contact then prints in the air

    nevermind got it too ha ha!
    Post by: Mark Howe, Sep 20, 2016 in forum: Troubleshooting
  2. Mark Howe
    Post

    Solved only 7 points make contact then prints in the air

    OK I fixed it I just tried reset or recalibrated everything and it started to work normal, I know the real reason is because you people out there...
    Post by: Mark Howe, Sep 20, 2016 in forum: Troubleshooting
  3. Mark Howe
    Thread

    Solved only 7 points make contact then prints in the air

    I am new at this, I read up on other forum answers about how to adjust the Z Axis offset if my printer prints in the air but I am up against...
    Thread by: Mark Howe, Sep 20, 2016, 3 replies, in forum: Troubleshooting
  4. Mark Howe
    Post

    Unanswered Is this extra goo normal?

    I'm really new at all this, can you explain to me a what a skirt is and where to look for calibration? I'll pick on this quick just need some...
    Post by: Mark Howe, Jun 30, 2016 in forum: General Questions
  5. Mark Howe
    Thread

    Unanswered Is this extra goo normal?

    I'm new and just printing out small stuff. When I print I seem to get extra goo around the foundation of what I have. Is this normal if not can I...
    Thread by: Mark Howe, Jun 30, 2016, 5 replies, in forum: General Questions
  6. Mark Howe
    Post

    Unresolved Few basic questions

    Awesome thanks that was it! Funny how the most simple things to others are a big deal till you know and realize how simple they are ha ha!
    Post by: Mark Howe, Jun 29, 2016 in forum: Troubleshooting
  7. Mark Howe
    Thread

    Unresolved Few basic questions

    Hello everyone thanks for having me, I have a question, I have the "R1" and I'm using matter control. I tried to print a small box and when it...
    Thread by: Mark Howe, Jun 28, 2016, 2 replies, in forum: Troubleshooting
  8. Mark Howe
    Post

    Unresolved 1 secont print times?

    Hey guys thanks for having me, I'm new at everything and I have the same problem but rotating doesn't work. I have Matter Control 1.5 and my file...
    Post by: Mark Howe, Jun 20, 2016 in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again