1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Baird Bankovic
    Post

    Coffee Heater

    No, the point is to learn about these technologies by tinkering with them. And a build plate heater is cheep, I have a transformer that meets the...
    Post by: Baird Bankovic, Jul 18, 2017 in forum: Projects
  2. Baird Bankovic
    Post

    Coffee Heater

    Ok, thanks for the info, and my dad is am electrical engineer so he can help with the rest, have a good day!
    Post by: Baird Bankovic, Jul 18, 2017 in forum: Projects
  3. Baird Bankovic
    Post

    Coffee Heater

    Amps? And I want to add a temp variation, could I do that by lowering the voltage through a variable resistor?
    Post by: Baird Bankovic, Jul 18, 2017 in forum: Projects
  4. Baird Bankovic
    Thread

    Coffee Heater

    Hello, so I have an old heater from a robo r1 plus build plate and I want to make a coffee Heater with it. So I want to know what I would need if...
    Thread by: Baird Bankovic, Jul 18, 2017, 6 replies, in forum: Projects
  5. Baird Bankovic
    Post

    Answered Z axis issue - only goes up (sort of)

    Try lifting the Call carrage above the nuts that lift the Call carrage on the Z lead screws so that the nuts can spin freely. And then, manually...
    Post by: Baird Bankovic, Jun 16, 2017 in forum: Troubleshooting
  6. Baird Bankovic
    Post

    Solved Z Axis problem

    Ok, thx man big help!!!!
    Post by: Baird Bankovic, Jun 15, 2017 in forum: Troubleshooting
  7. Baird Bankovic
    Post

    Solved Z Axis problem

    Ok, could this be a flow rate issue, I just got done "calibrating" my flow rates, and then I started having this issue. And are stepper drivers...
    Post by: Baird Bankovic, Jun 15, 2017 in forum: Troubleshooting
  8. Baird Bankovic
    Post

    Solved Z Axis problem

    Is there a way to calibrate the z step distance like there is a way to calibrate the extrusion steps/mm
    Post by: Baird Bankovic, Jun 15, 2017 in forum: Troubleshooting
  9. Baird Bankovic
    Thread

    Solved Z Axis problem

    I am having z axis problems on my Robo R1 Printer. As the nozzle moves about, it periodically hits the print. I have had my printer for over a...
    Thread by: Baird Bankovic, Jun 15, 2017, 7 replies, in forum: Troubleshooting
  10. Baird Bankovic
    Post

    Unresolved Dual fan mod problems!

    The reason that the fan ducts would be aimed right at the extruder nozzle is so that the filament that comes out immediately hardens, making for...
    Post by: Baird Bankovic, Oct 21, 2016 in forum: Troubleshooting
  11. Baird Bankovic
    Profile Post

    If anyone is buying an r1+ contact me and you WILL get $50 off you printer and 5% off store items!!

    If anyone is buying an r1+ contact me and you WILL get $50 off you printer and 5% off store items!!
    Status update by Baird Bankovic, Sep 23, 2016
Showing results 1 to 11 of 11
Search Again