1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. jonrobertd
    Post

    Can't get bluprint to stick at all.

    I contacted Taulman, and not 10 minutes later I got a response asking for my address to send me a spool. I really believe what I have is...
    Post by: jonrobertd, Aug 2, 2016 in forum: General Questions
  2. jonrobertd
    Post

    Can't get bluprint to stick at all.

    went to 275/95, one thing I am noticing is it is very brittle. Still not sticking any but it breaks up easily.
    Post by: jonrobertd, Aug 2, 2016 in forum: General Questions
  3. jonrobertd
    Post

    Can't get bluprint to stick at all.

    current temps are 250/95. tried 260/108 as well, but nothing. 110 is limit on bed but if i put in anything over 108 it hardware errors.
    Post by: jonrobertd, Aug 2, 2016 in forum: General Questions
  4. jonrobertd
    Thread

    Can't get bluprint to stick at all.

    So I am trying bluprint, and can not get it to stick at all. Hairspray, glue, tape, combos, nothing sticks. tried so many temp settings it is not...
    Thread by: jonrobertd, Aug 2, 2016, 9 replies, in forum: General Questions
  5. jonrobertd
    Post

    ABS Share ABS print settings?

    Excellent, I love hairspray, so easy to apply and clean. ABS slurry sucks to clean off, but had to try it too, just can't stop warp.
    Post by: jonrobertd, Jul 26, 2016 in forum: Printing Filament
  6. jonrobertd
    Post

    ABS Share ABS print settings?

    Thank you. Hair spray, glue, blue tape, or squeaky clean glass? Oh, I guess with the factory .4mm nozzle run 2mm retraction?
    Post by: jonrobertd, Jul 26, 2016 in forum: Printing Filament
  7. jonrobertd
    Post

    ABS Share ABS print settings?

    Thanks for the tips y'all, i ordered Bluprint, so what do I need for heat settings?
    Post by: jonrobertd, Jul 26, 2016 in forum: Printing Filament
  8. jonrobertd
    Thread

    ABS Share ABS print settings?

    Is anyone willing to share their ABS print settings for me to import into MatterControl, I have tried everything to get my prints to not warp, or...
    Thread by: jonrobertd, Jul 24, 2016, 12 replies, in forum: Printing Filament
Showing results 1 to 8 of 8
Search Again