1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Barbara Yeats
    Post

    Unresolved Bed not heating - R23 light not turning on

    Yes please if you could send me the thread link I would appreciate it. Thank you!!
    Post by: Barbara Yeats, May 15, 2019 in forum: Troubleshooting
  2. Barbara Yeats
    Post

    Unresolved Bed not heating - R23 light not turning on

    Thank you, I will take a look.
    Post by: Barbara Yeats, May 15, 2019 in forum: Troubleshooting
  3. Barbara Yeats
    Thread

    Unresolved Bed not heating - R23 light not turning on

    Good evening My robo 3d r1+ bed is not heating up, I have replaced the green connectors, they were fine but I thought I would eliminate that...
    Thread by: Barbara Yeats, May 14, 2019, 7 replies, in forum: Troubleshooting
  4. Barbara Yeats
    Post

    Unresolved Clogged Extruder R1

    ok finally got it unclogged! That was a bitch! New problem, the Z axis is too high, 7" above the bed. It won't let me move it down and when I...
    Post by: Barbara Yeats, Jul 24, 2016 in forum: Troubleshooting
  5. Barbara Yeats
    Post

    Unresolved Clogged Extruder R1

    I was printing at 235F. The room that we print in is probably 70F, but it is not an isolated room. I I bought some airtight (vacuum sealed...
    Post by: Barbara Yeats, Jul 23, 2016 in forum: Troubleshooting
  6. Barbara Yeats
    Post

    Unresolved Clogged Extruder R1

    I agree! This is a new extruder, I think robo3d was able to print with it when they repaired my printer, but I haven't gotten a print from it yet....
    Post by: Barbara Yeats, Jul 23, 2016 in forum: Troubleshooting
  7. Barbara Yeats
    Post

    Unresolved Clogged Extruder R1

    That sounds terrible and nerve wracking, why must it be done hot?
    Post by: Barbara Yeats, Jul 23, 2016 in forum: Troubleshooting
  8. Barbara Yeats
    Post

    Unresolved Clogged Extruder R1

    My machine is r1, but the extruder is new they just added it, it is not the original.
    Post by: Barbara Yeats, Jul 23, 2016 in forum: Troubleshooting
  9. Barbara Yeats
    Thread

    Unresolved Clogged Extruder R1

    I recently received my printer back from Robo 3d. I sent it in for repairs. I still haven't gotten a good print yet. Now the extruder seems...
    Thread by: Barbara Yeats, Jul 22, 2016, 14 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again