1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Bobhmg
    Post

    Solved Updated to Arduino software and now this

    That did it. Thank you, thank you, thank you.
    Post by: Bobhmg, Aug 15, 2017 in forum: Troubleshooting
  2. Bobhmg
    Post

    Solved Updated to Arduino software and now this

    Tried that it will not compile. Get errors even with the recommend Arguino request for member 'position' in '* pos', which is of non-class type...
    Post by: Bobhmg, Aug 15, 2017 in forum: Troubleshooting
  3. Bobhmg
    Post

    Solved Updated to Arduino software and now this

    Yes I cannot post the link as it won't post. However I have version ROBO3DR1V3. I used the Hex file for Matter Control as I could not get the...
    Post by: Bobhmg, Aug 15, 2017 in forum: Troubleshooting
  4. Bobhmg
    Post

    Solved Updated to Arduino software and now this

    This is where I found the software. I figured it was safe since it was a Robo site. guide.robo3d.com/Wiki/ROBO_3D_Firmware_Release_Notes. Cannot...
    Post by: Bobhmg, Aug 15, 2017 in forum: Troubleshooting
  5. Bobhmg
    Thread

    Solved Updated to Arduino software and now this

    Can somebody please help. I updated to Arduino software that is posted on here and now my prints are coming out horrible. I have a Robo 3D r1 plus...
    Thread by: Bobhmg, Aug 15, 2017, 10 replies, in forum: Troubleshooting
  6. Bobhmg
    Post

    Solved Robo 3d plus 1

    Thank you for the link. Unfortunately I cannot get the front screw to loosen. I did manage to get it just enough to be able to pry the holder out...
    Post by: Bobhmg, Oct 17, 2016 in forum: Troubleshooting
  7. Bobhmg
    Thread

    Solved Robo 3d plus 1

    OK, I have a robo 3d plus 1 and it is jammed. I do not have the 2 screws on the side like everyone shows in their videos. How do I remove it to...
    Thread by: Bobhmg, Oct 17, 2016, 4 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again