1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. MiguelLancaster
    Post

    Unanswered Having trouble with first layers

    Thanks, wired it back up just light on the right side (red wire left, black wire right). Hope that's alright. Does anyone else encounter that if...
    Post by: MiguelLancaster, Sep 21, 2016 in forum: Troubleshooting
  2. MiguelLancaster
    Post

    Unanswered Having trouble with first layers

    Loose wires are on the left side of the machine Additional pictures: http://imgur.com/a/wgMPT
    Post by: MiguelLancaster, Sep 21, 2016 in forum: Troubleshooting
  3. MiguelLancaster
    Post

    Unanswered Having trouble with first layers

    Here are some photos http://imgur.com/a/nla4c I'm using a refurbished R1+ - this is only my second day printing with it so I'm starting from the...
    Post by: MiguelLancaster, Sep 21, 2016 in forum: Troubleshooting
  4. MiguelLancaster
    Thread

    Unanswered Having trouble with first layers

    On every shape that I attempt to print, I'm having a lot of trouble getting the beginning layers to print correctly. The resulting print, which...
    Thread by: MiguelLancaster, Sep 21, 2016, 11 replies, in forum: Troubleshooting
  5. MiguelLancaster
    Post

    Anyone else get a refurbished printer?

    Turned it on and everything seems to at least move around and heat up mostly correctly. Burned on filament, even though it may not cause an issue,...
    Post by: MiguelLancaster, Sep 17, 2016 in forum: General Questions
  6. MiguelLancaster
    Post

    Anyone else get a refurbished printer?

    I just got mine delivered. Extruder seems as though it might not be installed straight, and also has burnt on filament on the hot end. There is...
    Post by: MiguelLancaster, Sep 17, 2016 in forum: General Questions
  7. MiguelLancaster
    Post

    Economical ways to test printing in different colors

    Thank you for the reply. I'm sure I don't have much use for a lot of these colors, so the small quantity isn't that big of a deal. Just thought it...
    Post by: MiguelLancaster, Sep 8, 2016 in forum: Printing Filament
  8. MiguelLancaster
    Thread

    Economical ways to test printing in different colors

    I just ordered one of the refurbished R1 Plus printers today. This will be my first 3D printer and I'd like to experiment with different colored...
    Thread by: MiguelLancaster, Sep 7, 2016, 8 replies, in forum: Printing Filament
Showing results 1 to 8 of 8
Search Again