1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. robert trama
    Post

    Using Arduino board on Robo R2 project in process

    i am having trouble finding a 15 amp fuse holder that would fit where the 5 amp ptc fuse was. any suggestions as to where i can pick one up?
    Post by: robert trama, Dec 2, 2019 in forum: Mods and Upgrades
  2. robert trama
    Post

    Using Arduino board on Robo R2 project in process

    i think that is the spare port for the second hotend extruder
    Post by: robert trama, Nov 1, 2019 in forum: Mods and Upgrades
  3. robert trama
    Post

    Using Arduino board on Robo R2 project in process

    that looks interesting, ive actually emailed parts built a couple times through the website asking about the C2 main-board since it looks...
    Post by: robert trama, Oct 31, 2019 in forum: Mods and Upgrades
  4. robert trama
    Post

    Using Arduino board on Robo R2 project in process

    thank you Lance, i have 3 more questions, 1. to the right of F1 and F2 there is the 12v aux but on the wiring diagram posted it says 24v, am...
    Post by: robert trama, Oct 30, 2019 in forum: Mods and Upgrades
  5. robert trama
    Post

    Using Arduino board on Robo R2 project in process

    im getting ready to do this mod and just going through the wiring before i start and there are a few areas that i am not quite following,...
    Post by: robert trama, Oct 29, 2019 in forum: Mods and Upgrades
  6. robert trama
    Post

    Using Arduino board on Robo R2 project in process

    i had this problem with the ribbon cable and it ended up being a small tear win the wiring below the ribbon connector
    Post by: robert trama, Oct 29, 2019 in forum: Mods and Upgrades
  7. robert trama
    Post

    Marlin for the R2 - MESH Enabled

    i don't remember having to use either one of those commands when i set up my r1, looks like its back to the tutorial page for me
    Post by: robert trama, Oct 10, 2017 in forum: Mods and Upgrades
  8. robert trama
    Post

    Marlin for the R2 - MESH Enabled

    Does the R2 Mesh setup work the same way as it does for the R1?
    Post by: robert trama, Oct 10, 2017 in forum: Mods and Upgrades
Showing results 1 to 8 of 8
Search Again