1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. robertcfitch
    Post

    E3D v6 Information, Installation Guides, and Review

    I just meant as far as what advice was given that's all [emoji6] I didn't set it at 300% because I didn't know better but simply as a last ditch...
    Post by: robertcfitch, Jan 6, 2017 in forum: Mods and Upgrades
  2. robertcfitch
    Post

    E3D v6 Information, Installation Guides, and Review

    This wasn't about getting a bad first layer. It was about getting NO first layer lol It was literally pushing into the glass and just sliding...
    Post by: robertcfitch, Jan 6, 2017 in forum: Mods and Upgrades
  3. robertcfitch
    Post

    E3D v6 Information, Installation Guides, and Review

    I generally print with my first layer at 90-100% of my layer height. That was just a last ditch effort after multiple attempts at adjusting the z...
    Post by: robertcfitch, Jan 6, 2017 in forum: Mods and Upgrades
  4. robertcfitch
    Post

    E3D v6 Information, Installation Guides, and Review

    I was using .3mm layer height and set that to 300% (so .9mm plus the offset of .5mm) as a last ditch effort to get it off the plate. Sent from...
    Post by: robertcfitch, Jan 6, 2017 in forum: Mods and Upgrades
  5. robertcfitch
    Post

    E3D v6 Information, Installation Guides, and Review

    I tried changing it in s3d. I set it to .5mm and the first layer to 300% at .3mm layer height and it was still doing it. Strangely when I loaded...
    Post by: robertcfitch, Jan 6, 2017 in forum: Mods and Upgrades
  6. robertcfitch
    Post

    E3D v6 Information, Installation Guides, and Review

    This helped a ton! Only problem now is that no matter what I do (change first layer height, z offset, etc) I cant get it to print actually OFF the...
    Post by: robertcfitch, Jan 5, 2017 in forum: Mods and Upgrades
  7. robertcfitch
    Post

    XXL LCD controller plus Octoprint?

    Thanks bud! Been considering the upgrades and I like the features of both [emoji6] Sent from my iPhone using Tapatalk
    Post by: robertcfitch, Jan 4, 2017 in forum: General Questions
  8. robertcfitch
    Thread

    XXL LCD controller plus Octoprint?

    Hey guys! Quick question, could I use octoprint or astroprint via a raspberry pi and still be able to make on the fly changes with the XXL LCD...
    Thread by: robertcfitch, Jan 4, 2017, 3 replies, in forum: General Questions
Showing results 1 to 8 of 8
Search Again