1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Jay K
    Post

    How to replace nozzle?

    Thank you both for the replies. I'll get a wrench or small ratchet driver and give it a try.
    Post by: Jay K, Dec 4, 2016 in forum: General Questions
  2. Jay K
    Thread

    How to replace nozzle?

    I have a Robo 3D+ and I'm wondering how you all go about replacing the print nozzles. I recently had a bad jam and I needed to remove the...
    Thread by: Jay K, Dec 3, 2016, 23 replies, in forum: General Questions
  3. Jay K
    Post

    Solved Removing Hotend on R1+

    The tech said the rubbery stuff is standard now.... it's supposed to make for a better seal. But it sure makes it hard to get the extruder back...
    Post by: Jay K, Oct 26, 2016 in forum: Troubleshooting
  4. Jay K
    Post

    Solved Removing Hotend on R1+

    I just had the same experience... I pushed it as hard as I could and still couldn't get it back in. That brown rubbery stuff makes it really hard...
    Post by: Jay K, Oct 26, 2016 in forum: Troubleshooting
  5. Jay K
    Post

    Solved Removing Hotend on R1+

    Of course. Honestly I'm amazed that they provide 24-hour, apparently US-based support in the first place. It really distinguishes them from...
    Post by: Jay K, Oct 26, 2016 in forum: Troubleshooting
  6. Jay K
    Post

    Solved Removing Hotend on R1+

    I scheduled a call with their support later today - I'll see what they say before I scrape that off. Hopefully whoever I talk to today is a...
    Post by: Jay K, Oct 26, 2016 in forum: Troubleshooting
  7. Jay K
    Post

    Solved Removing Hotend on R1+

    Thanks for this info... I did loosen the rear screw and that helps. <y problem is now pushing the extruder assembly up enough to slide the...
    Post by: Jay K, Oct 26, 2016 in forum: Troubleshooting
  8. Jay K
    Post

    Solved Removing Hotend on R1+

    So I finally managed to pry the pull-tab piece out. Once out I can push the parts above and below it together a little and it turns out there's a...
    Post by: Jay K, Oct 26, 2016 in forum: Troubleshooting
  9. Jay K
    Post

    Solved Removing Hotend on R1+

    Just got my R1+ a couple of weeks ago. My nozzle is jammed and I'm trying to get it out to have a closer look. My pull-tab is plastic. When I...
    Post by: Jay K, Oct 25, 2016 in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again