1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Eli Rarey
    Post

    Solved Help! first print, nozzle dragging+scratching bed

    I loosened the right endstop and got the brass nut as inside it as the left side was, and re-tightened. M565's parameter finally seemed to make a...
    Post by: Eli Rarey, Nov 28, 2016 in forum: Troubleshooting
  2. Eli Rarey
    Post

    Solved Help! first print, nozzle dragging+scratching bed

    Alright, sorry for the long delay to reply, life outside 3D printing caught up to me. So, again, the problem is when it finishes G29, it doesn't...
    Post by: Eli Rarey, Nov 23, 2016 in forum: Troubleshooting
  3. Eli Rarey
    Post

    Solved Help! first print, nozzle dragging+scratching bed

    I have not touched the firmware since receiving the printer, but anything is worth a try, so I downloaded firmware from the...
    Post by: Eli Rarey, Nov 17, 2016 in forum: Troubleshooting
  4. Eli Rarey
    Post

    Solved Help! first print, nozzle dragging+scratching bed

    I found M565 in the exported g-code: ; settings from start_gcode G28 X0 Y0 Z0 ; home all axes G1 Z5 F5000 ; lift nozzle M109 S210 ; set the...
    Post by: Eli Rarey, Nov 15, 2016 in forum: Troubleshooting
  5. Eli Rarey
    Post

    Solved Help! first print, nozzle dragging+scratching bed

    I have confirmed that it does touch the bed 9 times before it moves to where the calibration circle print should begin, so that's good. When I...
    Post by: Eli Rarey, Nov 15, 2016 in forum: Troubleshooting
  6. Eli Rarey
    Thread

    Solved Help! first print, nozzle dragging+scratching bed

    I watched the video... everything seemed in order. Sending the printer to home on each axis via MatterControl controls tab appeared to work fine....
    Thread by: Eli Rarey, Nov 15, 2016, 14 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again