1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. BrettW
    Post

    Unanswered Scripted filament change R1/S3D

    [MEDIA] I hope this will help
    Post by: BrettW, Dec 28, 2016 in forum: General Questions
  2. BrettW
    Post

    Best Robo R1+ mods

    Interesting to note Geof, I received the printer and it is now operational. I'm printing a few small test prints then moving on to the bigger and...
    Post by: BrettW, Dec 22, 2016 in forum: Mods and Upgrades
  3. BrettW
    Post

    Best Robo R1+ mods

    Alright Mark, thank you I saw that thread earlier as well, its no good having a remote system without a way to shut it off if it goes awry.
    Post by: BrettW, Dec 17, 2016 in forum: Mods and Upgrades
  4. BrettW
    Post

    Best Robo R1+ mods

    Alright, I'll read up this and see if I will need to implement a Raspicam. Initially I won't be running the printer without me being by it's side...
    Post by: BrettW, Dec 17, 2016 in forum: Mods and Upgrades
  5. BrettW
    Post

    Best Robo R1+ mods

    Ok Mark, good to know. What is your reasoning for having a Raspberry Pi/ Camera? I also will have to look into the uses for OctoPi/ purchase a Pi...
    Post by: BrettW, Dec 17, 2016 in forum: Mods and Upgrades
  6. BrettW
    Post

    Best Robo R1+ mods

    Yes I understand for both, it will definitely be a steep learning curve. I believe I read somewhere that e3ds' hardened nozzles are compatible...
    Post by: BrettW, Dec 16, 2016 in forum: Mods and Upgrades
  7. BrettW
    Post

    Best Robo R1+ mods

    Thank you for the quick reply Geof I understand that speed and temps vary between different types of filament, I purchased both PLA and ABS from...
    Post by: BrettW, Dec 16, 2016 in forum: Mods and Upgrades
  8. BrettW
    Thread

    Best Robo R1+ mods

    Hello I would like to introduce myself, I have been looking at the Robo3d printer for roughly two years and I finally decided to pull the trigger...
    Thread by: BrettW, Dec 16, 2016, 17 replies, in forum: Mods and Upgrades
Showing results 1 to 8 of 8
Search Again