1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. mlbailey
    Post

    LCD hung after Update

    Here is the fix Robo Software developer Matt Pedler just emailed me, and it did in fact fix my issue: To fix your problem with your Robo C2 you...
    Post by: mlbailey, Sep 18, 2017 in forum: Troubleshooting
  2. mlbailey
    Post

    LCD hung after Update

    I am currently working with the VP of Robo Engineering via email regarding my issue. Once they give me a solution I'll post it here. I would hold...
    Post by: mlbailey, Sep 18, 2017 in forum: Troubleshooting
  3. mlbailey
    Post

    LCD hung after Update

    Thanks for the reply. I can actually access Octoprint via the browser and start a print that way. It works fine except I can't use the LCD menu....
    Post by: mlbailey, Sep 17, 2017 in forum: Troubleshooting
  4. mlbailey
    Thread

    LCD hung after Update

    I received an update notification today, so I updated my Robo C2. Afterwards, the LCD is hung on the Robo Ready screen, and I cannot use the menu.
    Thread by: mlbailey, Sep 17, 2017, 33 replies, in forum: Troubleshooting
  5. mlbailey
    Post

    Answered C2 Nozzle exchange

    Can you give me the link for the hotend you bought on Amazon? I'm not buying another one from Robo.
    Post by: mlbailey, May 22, 2017 in forum: General Questions
  6. mlbailey
    Post

    Answered C2 Nozzle exchange

    I heated it to 230 using the built in preheat script.
    Post by: mlbailey, May 22, 2017 in forum: General Questions
  7. mlbailey
    Post

    Answered C2 Nozzle exchange

    The nozzle is breaking off instead of screwing out. But, yes, I am holding the block with a wrench while turning the nozzle. I've now gone through...
    Post by: mlbailey, May 22, 2017 in forum: General Questions
  8. mlbailey
    Post

    Answered C2 Nozzle exchange

    I don't know about everyone else, but I have yet to be able to change my 0.4mm nozzle on my Robo C2. I've tried twice to unscrew the nozzle and...
    Post by: mlbailey, May 21, 2017 in forum: General Questions
Showing results 1 to 8 of 8
Search Again