1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Krish
    Post

    Unanswered how often will i have to change the robo 3d r1+ parts?

    Personally I have had to do the below on my R1 with Auto bed Levelling: - My bed wires caught on fire within 1 month of me getting the printer...
    Post by: Krish, Sep 21, 2016 in forum: Troubleshooting
  2. Krish
    Post

    Community Favorite Alternative to the Lead Screw Upgrade Kit

    Just wanted to mention, I've referred to this thread in a video I recently made. Its more to do with changing leadscrew motors instead of the...
    Post by: Krish, Sep 17, 2016 in forum: Mods and Upgrades
  3. Krish
    Post

    Unresolved Print Quality after Leadscrew Motor Upgrade (Non-official kit)

    A couple weeks back I had ordered a new belt and pulley set to keep as spare. I only had time to replace the X drive cog/pulley this weekend but I...
    Post by: Krish, Sep 4, 2016 in forum: Troubleshooting
  4. Krish
    Post

    Unresolved Print Quality after Leadscrew Motor Upgrade (Non-official kit)

    Thanks for the reply! Well, I will explain what I've done below - but to answer your question, no, I have not tried printing it in a different bed...
    Post by: Krish, Aug 31, 2016 in forum: Troubleshooting
  5. Krish
    Post

    Unresolved Print Quality after Leadscrew Motor Upgrade (Non-official kit)

    Thanks for the reply! So I get that that could be the case. I had seen those visual trouble shooting guides and that's why I lowered the print...
    Post by: Krish, Aug 30, 2016 in forum: Troubleshooting
  6. Krish
    Thread

    Unresolved Print Quality after Leadscrew Motor Upgrade (Non-official kit)

    Hi all, So this weekend I did Leadscrew stepper motor upgrade using locally sourced parts (Australia). Apart from a few issues along the way with...
    Thread by: Krish, Aug 29, 2016, 10 replies, in forum: Troubleshooting
  7. Krish
    Post

    Lead Screw Upgrade Question

    Thanks again Mark for the links! Well mine being the R1 with auto bed levelling model from a while back, its not a brass nut iirc its the same...
    Post by: Krish, Aug 16, 2016 in forum: General Questions
  8. Krish
    Thread

    Lead Screw Upgrade Question

    Hi all, Been a while since I've done some printing with my Robo R1, but as I am getting back into it, my z ribbing issue is still there. As I am...
    Thread by: Krish, Aug 10, 2016, 5 replies, in forum: General Questions
Showing results 1 to 8 of 8
Search Again