1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Bultmann
    Post

    How to Update and Edit Robo firmware with Arduino

    getting a 'site deactivated' message when i go to the release notes page... has this been moved or discontinued?
    Post by: Bultmann, Jul 24, 2018 in forum: Software
  2. Bultmann
    Post

    Solved advice on troubleshooting extruder

    finally got around to installing new RAMPS. It was fairly easy, and printer is back and working. Thanks @Geof, @mark tomlinson
    Post by: Bultmann, Sep 28, 2017 in forum: Troubleshooting
  3. Bultmann
    Post

    Solved advice on troubleshooting extruder

    Thanks @Geof! will do.
    Post by: Bultmann, Sep 5, 2017 in forum: Troubleshooting
  4. Bultmann
    Post

    Solved advice on troubleshooting extruder

    excellent advice mark. thanks I'll proceed with amazon route first
    Post by: Bultmann, Sep 5, 2017 in forum: Troubleshooting
  5. Bultmann
    Post

    Solved advice on troubleshooting extruder

    oh thanks -- i definitely missed that point. I have the R1+ I see that Robo sells the Arduino + RAMPS ($96, yikes) or the Arduino, but not the...
    Post by: Bultmann, Sep 5, 2017 in forum: Troubleshooting
  6. Bultmann
    Thread

    Solved advice on troubleshooting extruder

    my extruder quit responding over the weekend... when i manually progress the stepper motor (via optoprint or mattercontrol), the arduino flashes...
    Thread by: Bultmann, Sep 5, 2017, 8 replies, in forum: Troubleshooting
  7. Bultmann
    Thread

    Hello folks from Springfield IL

    I bought a stock R1+ second hand about a month a go... and i've been lurking and printing like mad since. A lot of very specific R1 help in here....
    Thread by: Bultmann, Apr 24, 2017, 1 replies, in forum: United States of America
Showing results 1 to 7 of 7
Search Again