1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. formtechn
    Thread

    Answered How to readjust the z offset

    How to readjust the z offset on r1+? I just switch to e3d v6 and the nozzle is close to the plate, which is not allowing the filament to come out...
    Thread by: formtechn, May 2, 2017, 9 replies, in forum: Troubleshooting
  2. formtechn
    Thread

    Robo R1 + is horrible (for sale)

    This 3d printer has been breaking on me like crazy. I am looking to sell if and buy a 3d printer that has been customer service. Contact me at...
    Thread by: formtechn, Apr 20, 2017, 18 replies, in forum: General Questions
  3. formtechn
    Thread

    Answered Heater block is loose

    I thought my thermistor was messed up, but I have come to the conclusion that my heater block get loose when it get to 130 degrees and then I can...
    Thread by: formtechn, Apr 18, 2017, 1 replies, in forum: Troubleshooting
  4. formtechn
    Post

    Thermistor for Robo R1

    R1 Plus
    Post by: formtechn, Apr 12, 2017 in forum: Mods and Upgrades
  5. formtechn
    Thread

    Thermistor for Robo R1

    Is there a place I can buy extra thermistor for my robo r1. I would like to have some spares at the house.
    Thread by: formtechn, Apr 12, 2017, 13 replies, in forum: Mods and Upgrades
  6. formtechn
    Post

    Solved Extruder Will not Pre Heat

    This is the error I received.
    Post by: formtechn, Apr 11, 2017 in forum: Troubleshooting
  7. formtechn
    Post

    Solved Extruder Will not Pre Heat

    [IMG] Sent from my iPhone using Tapatalk
    Post by: formtechn, Apr 11, 2017 in forum: Troubleshooting
  8. formtechn
    Post

    Solved Extruder Will not Pre Heat

    Should they have 2 screws right here Sent from my iPhone using Tapatalk
    Post by: formtechn, Apr 11, 2017 in forum: Troubleshooting
  9. formtechn
    Thread

    Solved Extruder Will not Pre Heat

    Yesterday I switch to a 1.75mm PLA filament and printed 4 items without a problem. Once I began to start on the next item, my extruder temperature...
    Thread by: formtechn, Apr 11, 2017, 6 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again