1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Jaykav99
    Thread

    Does a smaller nozzle guarantee better details?

    Possibly kind of a newb question but I've been printing awhile now and have stuck with the 0.4 diameter nozzles. And now i am getting into objects...
    Thread by: Jaykav99, May 8, 2018, 6 replies, in forum: Off Topic
  2. Jaykav99
    Thread

    List of material types

    Hey guys is there an official list somewhere that robo says the R2 works with or at least tested with. Store page just says 30+
    Thread by: Jaykav99, Aug 27, 2017, 9 replies, in forum: General Questions
  3. Jaykav99
    Thread

    Failed Thor Hammer Steel print, but wow it was going well. Pics inside

    So basically the filament appeared to snap and then clogged my extruder, sucks but what can you do...it was about 25%(4hrs) done or so and the...
    Thread by: Jaykav99, Jul 22, 2017, 7 replies, in forum: Show and Tell
  4. Jaykav99
    Thread

    Filament pulling failure during print.

    Was about 20 % through printing benchy...and then i heard a sound dadadadadadadadadadada then i noticed the wheels aren't spinning at all to pull...
    Thread by: Jaykav99, Jul 19, 2017, 7 replies, in forum: Troubleshooting
  5. Jaykav99
    Thread

    Over all Speed Settings

    I know this must be a broad question but what would be a typical safe print speed for the R2. I have the R1+ right now and would hope I can take...
    Thread by: Jaykav99, Jul 17, 2017, 4 replies, in forum: General Questions
  6. Jaykav99
    Thread

    Solved Printing goes off axis mid print

    This might be a slicer issue over all but. I was printing a music box out and as it layed down the first layer everything is good. Then second...
    Thread by: Jaykav99, Apr 10, 2017, 15 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again